Optimization of Drilling Parameters During Machining of Al-Mg-Si Alloys By Taguchi Method Coupled with Grey Relational Analysis and Validated By Fea Based Deform - 3D
and
Dec 07, 2021
About this article
Published Online: Dec 07, 2021
Page range: 221 - 238
DOI: https://doi.org/10.2478/scjme-2021-0032
Keywords
© 2021 Reddy Sreenivasulu et al., published by Sciendo
This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.
Sreenivasulu, Reddy
Department of Mechanical Engineering, R.V.R & J. C. College of Engineering (A)India
Srinivasarao, Chalamalasetti
Department of Mechanical Engineering, College of Engineering (A), Andhra UniversityVishakhapatnam, India