Accès libre

Optimization of Drilling Parameters During Machining of Al-Mg-Si Alloys By Taguchi Method Coupled with Grey Relational Analysis and Validated By Fea Based Deform - 3D

Reddy Sreenivasulu

Reddy Sreenivasulu

Department of Mechanical Engineering, R.V.R & J. C. College of Engineering (A)India
Recherchez cet auteur sur
Sciendo|Google Scholar
Sreenivasulu, Reddy
 et 
Chalamalasetti Srinivasarao

Chalamalasetti Srinivasarao

Department of Mechanical Engineering, College of Engineering (A), Andhra UniversityVishakhapatnam, India
Recherchez cet auteur sur
Sciendo|Google Scholar
Srinivasarao, Chalamalasetti
  
07 déc. 2021
Optimization of Drilling Parameters During Machining of Al-Mg-Si Alloys By Taguchi Method Coupled with Grey Relational Analysis and Validated By Fea Based Deform - 3D's Cover Image
À propos de cet article
Article précédent
Article suivant
Citez
Télécharger la couverture
Publié en ligne: 07 déc. 2021
Pages: 221 - 238
DOI: https://doi.org/10.2478/scjme-2021-0032
Mots clés
© 2021 Reddy Sreenivasulu et al., published by Sciendo
This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.
Sreenivasulu, Reddy
Department of Mechanical Engineering, R.V.R & J. C. College of Engineering (A)India
Srinivasarao, Chalamalasetti
Department of Mechanical Engineering, College of Engineering (A), Andhra UniversityVishakhapatnam, India
Langue:
Anglais
Périodicité:
2 fois par an
Sujets de la revue:
Ingénierie, Génie mécanique, Fondamentaux du génie mécanique, Mécanique
RSS Feed de la revue