<abstract xmlns="http://www.w3.org/1999/xhtml">

<p>In the present work to validate the experimental results as per Taguchi based grey relational analysis by considering L<sub>27</sub> orthogonal array corresponding to five factors with three levels and obtained optimal combination of input parameters to minimize the output responses during drilling process which is most important finishing operation required in the structural assembly works where we found application of Al-Mg-Si alloys, Deform-3D software is implemented and found good feasibility with that of experimental results.</p>
</abstract>

In the present work to validate the experimental results as per Taguchi based grey relational analysis by considering L27 orthogonal array corresponding to five factors with three levels and obtained optimal combination of input parameters to minimize the output responses during drilling process which is most important finishing operation required in the structural assembly works where we found application of Al-Mg-Si alloys, Deform-3D software is implemented and found good feasibility with that of experimental results.

Optimization of Drilling Parameters During Machining of Al-Mg-Si Alloys By Taguchi Method Coupled with Grey Relational Analysis and Validated By Fea Based Deform - 3D

College of Engineering (A), Andhra University

Strojnícky časopis - Journal of Mechanical Engineering

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

In the present work to validate the experimental results as per Taguchi based grey relational analysis by considering L27 orthogonal array corresponding to...

Optimization of Drilling Parameters During Machining of Al-Mg-Si Alloys By Taguchi Method Coupled with Grey Relational Analysis and Validated By Fea Based Deform - 3D

Published Online: Dec 07, 2021

Page range: 221 - 238

DOI: https://doi.org/10.2478/scjme-2021-0032

Keywords
Grey based Taguchi Approach, Thrust force, Torque, Al-Mg-Si alloy, Deform-3D

© 2021 Reddy Sreenivasulu et al., published by Sciendo

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Optimization of Drilling Parameters During Machining of Al-Mg-Si Alloys By Taguchi Method Coupled with Grey Relational Analysis and Validated By Fea Based Deform - 3D

Published Online: Dec 07, 2021

Page range: 221 - 238

DOI: https://doi.org/10.2478/scjme-2021-0032

KeywordsGrey based Taguchi Approach, Thrust force, Torque, Al-Mg-Si alloy, Deform-3D

© 2021 Reddy Sreenivasulu et al., published by Sciendo

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Keywords
Grey based Taguchi Approach, Thrust force, Torque, Al-Mg-Si alloy, Deform-3D