Accesso libero

Optimization of Drilling Parameters During Machining of Al-Mg-Si Alloys By Taguchi Method Coupled with Grey Relational Analysis and Validated By Fea Based Deform - 3D

Reddy Sreenivasulu

Reddy Sreenivasulu

Department of Mechanical Engineering, R.V.R & J. C. College of Engineering (A)India
Cerca questo autore su
Sciendo|Google Scholar
Sreenivasulu, Reddy
 e 
Chalamalasetti Srinivasarao

Chalamalasetti Srinivasarao

Department of Mechanical Engineering, College of Engineering (A), Andhra UniversityVishakhapatnam, India
Cerca questo autore su
Sciendo|Google Scholar
Srinivasarao, Chalamalasetti
  
07 dic 2021
Optimization of Drilling Parameters During Machining of Al-Mg-Si Alloys By Taguchi Method Coupled with Grey Relational Analysis and Validated By Fea Based Deform - 3D's Cover Image
INFORMAZIONI SU QUESTO ARTICOLO
Articolo precedente
Articolo Successivo
Cita
Scarica la copertina
Pubblicato online: 07 dic 2021
Pagine: 221 - 238
DOI: https://doi.org/10.2478/scjme-2021-0032
Parole chiave
© 2021 Reddy Sreenivasulu et al., published by Sciendo
This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.
Sreenivasulu, Reddy
Department of Mechanical Engineering, R.V.R & J. C. College of Engineering (A)India
Srinivasarao, Chalamalasetti
Department of Mechanical Engineering, College of Engineering (A), Andhra UniversityVishakhapatnam, India
Lingua:
Inglese
Frequenza di pubblicazione:
2 volte all'anno
Argomenti della rivista:
Ingegneria, Ingegneria meccanica, Basi dell'ingegneria meccanica, Meccanica
Feed RSS della rivista