Accesso libero

Automatic Device with Self-Braking for Fixation Objects in Executive Links of Technological Equipment

Borys Prydalnyi

Borys Prydalnyi

Faculty of Transport and Mechanical Engineering, Department of Applied Mechanics and Mechatronics, Lutsk National Technical UniversityLutsk, Ukraine
Profilo Orcid
Cerca questo autore su
Sciendo|Google Scholar
Prydalnyi, Borys
  
31 mar 2025
Automatic Device with Self-Braking for Fixation Objects in Executive Links of Technological Equipment's Cover Image
INFORMAZIONI SU QUESTO ARTICOLO
Articolo precedente
Articolo Successivo
Cita
Scarica la copertina
Pubblicato online: 31 mar 2025
Pagine: 7 - 14
Ricevuto: 23 gen 2024
Accettato: 21 mag 2024
DOI: https://doi.org/10.2478/ama-2025-0002
Parole chiave
© 2025 Borys Prydalnyi, published by Sciendo
This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.

Fig. 1.

Mechanical CM’s actuator with geometric locking: a) functioning scheme in combination with a lever chuck (in the “clamped” state); b) general view of the mechanism (in the “unlocked” state)
Mechanical CM’s actuator with geometric locking: a) functioning scheme in combination with a lever chuck (in the “clamped” state); b) general view of the mechanism (in the “unlocked” state)

Fig. 2.

Design of the new electromechanical CM actuator
Design of the new electromechanical CM actuator

Fig. 3.

The scheme for calculating CM parameters
The scheme for calculating CM parameters

Fig. 4.

Dependence of clamping force TΣ in proposed CM from: a) frequency of rotation of the spindle n when the torque of the rotor of Тр = 66 Nm; b) torque Тр, which appears on the rotor at frequency of the spindle rotation n = 5000 rpm
Dependence of clamping force TΣ in proposed CM from: a) frequency of rotation of the spindle n when the torque of the rotor of Тр = 66 Nm; b) torque Тр, which appears on the rotor at frequency of the spindle rotation n = 5000 rpm

Fig. 5.

Design of the proposed clamping mechanism as part of the spindle assembly
Design of the proposed clamping mechanism as part of the spindle assembly

Fig. 6.

Scheme of the proposed clamping mechanism with electromechanical drive and hydraulic amplification system
Scheme of the proposed clamping mechanism with electromechanical drive and hydraulic amplification system
Lingua:
Inglese
Frequenza di pubblicazione:
4 volte all'anno
Argomenti della rivista:
Ingegneria, Elettrotecnica, Elettronica, Ingegneria meccanica, Meccanica, Bioingegneria ed ingegneria biomedicale, Biomeccanica, Ingegneria civile, Ingegneria ambientale
Feed RSS della rivista