The Journal of Institute of Measurement Science of Slovak Academy of Sciences

Measurement Science Review

<abstract xml:lang="en"><title style='display:none'>Model for Cuboid Shape Samples and its Analysis Used for Measurements of Thermophysical Properties of Sandstone</title>A new model for the sample of square cross section with cuboid geometry including the effect of heat loss from the surface of the sample was tested using the theory of sensitivity coefficients. Theoretical calculation of model uncertainty and derived analytical formulas are presented. Results of the uncertainty analysis set out the range of experimental conditions under which the model is valid and the uncertainty of estimated parameters is low. Propagation of error for non-stochastic dynamic measurements based on the sensitivity coefficients shows limitations related to a range of model validity. The analysis improves the accuracy of measurements. The model was used for data evaluation of thermophysical parameters measured on the sandstone from the locality Pravčická brána. Evaluation procedure was tested on experimental data measured under different experimental conditions. In conclusion, the discussion of the experiment optimization is presented.</abstract>

Model for Cuboid Shape Samples and its Analysis Used for Measurements of Thermophysical Properties of Sandstone

Institute of Physics, Slovak Academy of Sciences, Bratislava, Slovakia

Department of Physics, FEI - STU, Ilkovičova 3, Bratislava, Slovakia

Department of Engineering Geology, Faculty of Natural Sciences, Comenius University, Mlynská dolina, Bratislava, Slovakia

Keywords

<article-title>Model for Cuboid Shape Samples and its Analysis Used for Measurements of Thermophysical Properties of Sandstone</article-title>

Measurement Science Review is covered by the following services: <UL> <LI>Astrophysics Data System (ADS) </LI> <LI>Baidu Scholar </LI> <LI>Cabell's Whitelist </LI> <LI>Case </LI> <LI>CNKI Scholar (China National Knowledge Infrastructure) </LI> <LI>CNPIEC - cnpLINKer </LI> <LI>Dimensions </LI> <LI>DOAJ (Directory of Open Access Journals) </LI> <LI>EBSCO </LI> <LI>Ei Compendex </LI> <LI>ExLibris </LI> <LI>Google Scholar </LI> <LI>Inspec </LI> <LI>Japan Science and Technology Agency (JST) </LI> <LI>J-Gate </LI> <LI>Journal Citation Reports/Science Edition </LI> <LI>JournalGuide </LI> <LI>JournalTOCs </LI> <LI>KESLI-NDSL (Korean National Discovery for Science Leaders) </LI> <LI>MyScienceWork </LI> <LI>Naver Academic </LI> <LI>Naviga (Softweco) </LI> <LI>ProQuest </LI> <LI>QOAM (Quality Open Access Market) </LI> <LI>ReadCube </LI> <LI>Reaxys </LI> <LI>SCILIT </LI> <LI>SCImago (SJR) </LI> <LI>SCOPUS </LI> <LI>Semantic Scholar </LI> <LI>Sherpa/RoMEO </LI> <LI>TDNet </LI> <LI>TEMA Technik und Management </LI> <LI>Ulrich's Periodicals Directory/ulrichsweb </LI> <LI>WanFang Data </LI> <LI>Web of Science - Current Contents/Engineering, Computing, and Technology </LI> <LI>Web of Science - Essential Science Indicators </LI> <LI>Web of Science - Science Citation Index Expanded </LI> <LI>WorldCat (OCLC) </LI> <LI>X-MOL </LI></UL>

Measurement Science Review ist in den folgenden Services indiziert: <UL> <LI>Astrophysics Data System (ADS) </LI> <LI>Baidu Scholar </LI> <LI>Cabell's Whitelist </LI> <LI>Case </LI> <LI>CNKI Scholar (China National Knowledge Infrastructure) </LI> <LI>CNPIEC - cnpLINKer </LI> <LI>Dimensions </LI> <LI>DOAJ (Directory of Open Access Journals) </LI> <LI>EBSCO </LI> <LI>Ei Compendex </LI> <LI>ExLibris </LI> <LI>Google Scholar </LI> <LI>Inspec </LI> <LI>Japan Science and Technology Agency (JST) </LI> <LI>J-Gate </LI> <LI>Journal Citation Reports/Science Edition </LI> <LI>JournalGuide </LI> <LI>JournalTOCs </LI> <LI>KESLI-NDSL (Korean National Discovery for Science Leaders) </LI> <LI>MyScienceWork </LI> <LI>Naver Academic </LI> <LI>Naviga (Softweco) </LI> <LI>ProQuest </LI> <LI>QOAM (Quality Open Access Market) </LI> <LI>ReadCube </LI> <LI>Reaxys </LI> <LI>SCILIT </LI> <LI>SCImago (SJR) </LI> <LI>SCOPUS </LI> <LI>Semantic Scholar </LI> <LI>Sherpa/RoMEO </LI> <LI>TDNet </LI> <LI>TEMA Technik und Management </LI> <LI>Ulrich's Periodicals Directory/ulrichsweb </LI> <LI>WanFang Data </LI> <LI>Web of Science - Current Contents/Engineering, Computing, and Technology </LI> <LI>Web of Science - Essential Science Indicators </LI> <LI>Web of Science - Science Citation Index Expanded </LI> <LI>WorldCat (OCLC) </LI> <LI>X-MOL </LI></UL>

<DIV align=left> The aim of the journal is to publish papers from scientific disciplines covering the Measurement science with an orientation toward the theory of measurement, measurement of physical quantities and measurement in biomedicine. The parameters of the journal increase the attractiveness of the magazine for many foreign authors and is considered as "significant international magazine", where published articles by authors from both European and non-European countries capture the latest trends in the field of the measurement science. Independent peer-reviewers are evaluating the submitted manuscripts. The advantage of the on-line edition of the Journal will be the speed of publication, just in a short time after receiving positive reports from reviewers. Journal is indexed in 42 databases, e.g.: Current Contents®/Engineering Computing and Technology, Thomson Reuters Master Journal List, ISI Web of Knowledge, Index Copernicus International, Scopus, Electronic Journals Library, … Editorial Board includes 38 scientists from all continents of world. The number of applications to be a member of the International Editorial Board of the MSR magazine, mainly from abroad, is increasing every year. It is generally known that Measurement science is the Science of sciences – there is no science without measurement. Each measuring process assumes an object of measurement. No phenomenon is a real phenomenon unless it observable in space and time, that is, unless it is a subject to measurement. The science of measurement is an indispensable ingredient in all scientific fields. Mathematical foundations and interpretation of the measurement science were accepted and further developed in most of the scientific fields, including physics, cosmology, geology, environment, quantum mechanics, statistics and metrology. Why subscribe and read Journal is providing an environment for information exchange among scientists, engineers and industry people, as well as encouragement of effective and coordinated research cooperation. Why submit <UL> <LI>Publishes only original articles with complete proofs by assuring a high quality reviewing process.</LI> <LI>On-line edition is an official journal of the Institute of Measurement. </LI> <LI>Science and also journal of the International Conference MEASUREMENT. </LI></UL> Archiving Sciendo archives the contents of this journal in <A href="https://www.portico.org/">Portico</A> - digital long-term preservation service of scholarly books, journals and collections. Plagiarism Policy The editorial board is participating in a growing community of <A href="https://www.crossref.org/services/similarity-check/">Similarity Check System's</A> users in order to ensure that the content published is original and trustworthy. Similarity Check is a medium that allows for comprehensive manuscripts screening, aimed to eliminate plagiarism and provide a high standard and quality peer-review process. </DIV>

Editor-in-Chief: Ivan Frollo, Institute of Measurement Science, Slovak Academy of Sciences, Slovakia Executive Editors: Viktor Witkovský, Institute of Measurement Science, Slovak Academy of Sciences, Slovakia Ida Prokopčáková, Institute of Experimental Psychology, Slovak Academy of Sciences, Slovakia Editor: Vladimír Juráš, Institute of Measurement Science, Slovak Academy of Sciences, Slovakia Editorial Board: Olli Aumala, Tampere University of Technology, Finland Denny Borsboom, Department of Psychology, University of Amsterdam, The Netherlands Isabel Van Driessche, Ghent University-Laboratory of Organometallics and Catalysis, Belgium Zoltán Domotor, Department of Philosophy, University of Pennsylvania, Philadelphia, U.S.A. Miroslav Dovica, Technical University of Košice, Slovakia Stanislav Duriš, Technical University Bratislava, Slovakia Osman Gencel, Faculty of Engineering, Bartin University, Bartin, Turkey Adam Glowacz, AGH University of Science and Technology, Poland Marco L. H. Gruwel, Department of Chemistry, University of Manitoba, Winnipeg, Canada Yuri V. Chugui, Technological Design Institute of Scientific Instrument Engineering, Russia Dietrich Hofmann, SpectroNet - International Collaboration Cluster, Jena, Germany Dariusz J. Jakóbczak, Technical University of Koszalin, Poland György Kozmann, CRIP Research Institute for Technical Physics and Material Science, Hungary Vitalij Novickij, Vilnius Gediminas Technical University, Lithuania Ignacio Lira, Pontificia Universidad Catolica de Chile, Chile Kalju Meigas, Tallinn University of Technology, Estonia Rosario Morello, University Mediterranea of Reggio Calabria, Italy Ganesh R. Naik, Faculty of Engng &amp; Inf. Technology Univ. of Technology, Sydney, Australia Irina G. Palchikova, Technological Design Institute of Scientific Instrument Engineering, Russia Rudolf Palenčár, Technical University Bratislava, Slovakia Nicola Pasquino, University of Naples Federico II, Napoli, Italy Sudheer Rani, Vanderbilt University Institute of Imaging Sciences, Nashville, U.S.A. Paul Regtien, Faculty of Electrical Engineering at the University of Twente, The Netherlands Mario Savino, Politecnico di BARI, Italy Viktor Smieško, Technical University Bratislava, Slovakia Harald Schumny, Physikalisch- Technische Bundesanstalt, Germany Manuch Soleimani, University of Bath, Claverton Down, Bath, UK Michael G. Sowa, Institute for Biodiagnostics, National Research Council of Canada, Canada Peter H. Sydenham, University of South Australia and GSEC Pty Ltd, Australia Zenon Starčuk, Institute of Scientific Instruments, Academy of Sciences, Czech Republic Mihai Tarata, Dept. of Med. Informatics, Uni. of Medicine and Pharmacy of Craiova, Romania Shigeru Takayama, Ritsumeikan University BKC, Faculty of Science and Engineering, Japan Milan Tyšler, Institute of Measurement Science , Slovak Academy of Sciences , Slovakia Julia Volaufova, Louisiana State University Health Sciences Center, New Orleans, U.S.A. Werner Wolf, Universität der Bundeswehr, München, Germany Jan Zakrzewski, Silesian Univ. of Technology, Dep. of Measurement and El. Control, Poland T. Yuvaraja, Channabasaveshwara Institute of Technology, Tumkur City, India Orest Kochan, Lviv Polytechnic National University, Lviv, Ukraine Tao Wang, Shanghai Jiao Tong University, Shanghai, China Language Editor: Ida Prokopčáková, Institute of Experimental Psychology, Slovak Academy of Sciences, Slovakia Technical Editors: Eva Nagyová, Institute of Measurement Science, Slovak Academy of Sciences, Slovakia Katarína Kozáková, Institute of Measurement Science, Slovak Academy of Sciences, Slovakia Contact: Institute of Measurement Science Slovak Academy of Sciences Dubravska 9. 841 04 BRATISLAVA Slovak Republic Tel: +4212 5910 4511 - secretary of the director, <A href="mailto:umersekr@savba.sk">umersekr@savba.sk</A> Fax: +4212 5910 4594 <A href="http://www.um.sav.sk/en/">www.um.sav.sk/en/</A> Publisher: De Gruyter Poland Bogumiła Zuga 32A Str. 01-811 Warsaw, Poland

Please change to: Please submit your manuscripts to Measurement Science Review via email to: <A href="mailto:measurement@savba.sk">measurement@savba.sk</A> or via webpage: <A href="https://journals.savba.sk/index.php/msr/index">https://journals.savba.sk/index.php/msr/index</A> Preparation of papers, instructions: <A href="http://www.measurement.sk/Instructions.htm">www.measurement.sk/Instructions.htm</A>. <A href="https://www.measurement.sk/Instructions.htm">Template</A> for your paper. Article Processing Charge (APC) 50 EUR Open Access Statement The journal is an Open Access journal that allows a free unlimited access to all its contents without any restrictions upon publication to all users. <A href="https://sciendo-parsed-data-feed.s3.eu-central-1.amazonaws.com/MSR/Open_Access_License.pdf">Open Access License</A>

Measurement Science Review

Model for Cuboid Shape Samples and its Analysis Used for Measurements of Thermophysical Properties of Sandstone

V. Boháč,
V. Boháč,
P. Dieška,
P. Dieška,
V. Vretenár oraz
V. Vretenár oraz
V. Greif
V. Greif

Data publikacji: 21 Dec 2011

Tom & Zeszyt: Tom 11 (2011) - Zeszyt 6 (December 2011)

Zakres stron: 192 - 197

Dziennik i szczegóły wydania

Measurement Science Review

Podgląd PDF

Referencje

Najnowsze artykuły

Measurement Science Review

Model for Cuboid Shape Samples and its Analysis Used for Measurements of Thermophysical Properties of Sandstone

V. Boháč,V. Boháč,P. Dieška,P. Dieška,V. Vretenár orazV. Vretenár orazV. GreifV. Greif

Data publikacji: 21 Dec 2011

Tom & Zeszyt: Tom 11 (2011) - Zeszyt 6 (December 2011)

Zakres stron: 192 - 197

Dziennik i szczegóły wydania

Measurement Science Review

Podgląd PDF

Referencje

Najnowsze artykuły

V. Boháč,
V. Boháč,
P. Dieška,
P. Dieška,
V. Vretenár oraz
V. Vretenár oraz
V. Greif
V. Greif