<abstract xmlns="http://www.w3.org/1999/xhtml">

<p>The paper presents a numerical analysis of the behaviour of egg-shaped glass-reinforced plastic (GRP) panels during the grouting process when using short relining technology. The analysis was carried out for panels subjected to temperature changes. The temperature increase was caused by the heat of hydration of the grout. It was shown that temperature had a significant effect on the stresses occurring in the panels’ walls and also on their deformations. The analysis involved grout being added in a single stage and then in two stages for comparison. The distribution of stresses and deformations were examined for panels with different wall thicknesses that ranged from 12 to 20 mm. Extensive knowledge about the grouting process and the effect of temperature on the behaviour of GRP panels during the assembly stage when using short relining technology could make this non-disruptive technology more competitive with regards to the time of its implementation and its costs when compared to traditional methods.</p>
</abstract>

The paper presents a numerical analysis of the behaviour of egg-shaped glass-reinforced plastic (GRP) panels during the grouting process when using short relining technology. The analysis was carried out for panels subjected to temperature changes. The temperature increase was caused by the heat of hydration of the grout. It was shown that temperature had a significant effect on the stresses occurring in the panels’ walls and also on their deformations. The analysis involved grout being added in a single stage and then in two stages for comparison. The distribution of stresses and deformations were examined for panels with different wall thicknesses that ranged from 12 to 20 mm. Extensive knowledge about the grouting process and the effect of temperature on the behaviour of GRP panels during the assembly stage when using short relining technology could make this non-disruptive technology more competitive with regards to the time of its implementation and its costs when compared to traditional methods.

Analysis of the temperature effect on the stresses and deformations of GRP panels during the grouting process when using relining technology

Wroclaw University of Science and Technology: Politechnika Wroclawska

Studia Geotechnica et Mechanica

This work is licensed under the Creative Commons Attribution 4.0 International License.

The paper presents a numerical analysis of the behaviour of egg-shaped glass-reinforced plastic (GRP) panels during the grouting process when using short...

Analysis of the temperature effect on the stresses and deformations of GRP panels during the grouting process when using relining technology

Article Category: Special Issue Article

Data publikacji: 22 gru 2021

Zakres stron: 521 - 531

Otrzymano: 31 sie 2021

Przyjęty: 05 lis 2021

DOI: https://doi.org/10.2478/sgem-2021-0032

Słowa kluczowe
relining technology, GRP, grouting process, temperature

© 2021 Zuzanna Fyall, published by Sciendo

This work is licensed under the Creative Commons Attribution 4.0 International License.

Analysis of the temperature effect on the stresses and deformations of GRP panels during the grouting process when using relining technology

Article Category: Special Issue Article

Data publikacji: 22 gru 2021

Zakres stron: 521 - 531

Otrzymano: 31 sie 2021

Przyjęty: 05 lis 2021

DOI: https://doi.org/10.2478/sgem-2021-0032

Słowa kluczowerelining technology, GRP, grouting process, temperature

© 2021 Zuzanna Fyall, published by Sciendo

This work is licensed under the Creative Commons Attribution 4.0 International License.

Słowa kluczowe
relining technology, GRP, grouting process, temperature