<abstract xmlns="http://www.w3.org/1999/xhtml"><p>The paper deals with the problem of shape optimization of underground tunnel excavation. In the pioneering work of Sałustowicz, the elliptic shape was assumed a priori to be an optimal one and then a determination of suitable semi-axes ratio was only the question. Two cases were distinguished there: self-supporting excavation and excavation with the structural support. An evolutionary structural optimization (ESO) procedure, employed in 2005 to optimize shape of underground excavation, confirms the assumptions concerning the case of self-supporting excavations. The case of supported excavation is considered in the present work. Optimization procedure of the simulated annealing (SA) is incorporated in the study. An energetic optimality condition, formulated in the authors’ previous papers is also adopted. Itasca FLAC software is utilized in numerical examples. Four different in situ stress ratios are investigated. The numerical results obtained confirm that the optimal shape tends to be an ellipse. The semi-axes ratio demonstrates compliance with the assumptions already existing in literature.</p></abstract>

The paper deals with the problem of shape optimization of underground tunnel excavation. In the pioneering work of Sałustowicz, the elliptic shape was assumed a priori to be an optimal one and then a determination of suitable semi-axes ratio was only the question. Two cases were distinguished there: self-supporting excavation and excavation with the structural support. An evolutionary structural optimization (ESO) procedure, employed in 2005 to optimize shape of underground excavation, confirms the assumptions concerning the case of self-supporting excavations. The case of supported excavation is considered in the present work. Optimization procedure of the simulated annealing (SA) is incorporated in the study. An energetic optimality condition, formulated in the authors’ previous papers is also adopted. Itasca FLAC software is utilized in numerical examples. Four different in situ stress ratios are investigated. The numerical results obtained confirm that the optimal shape tends to be an ellipse. The semi-axes ratio demonstrates compliance with the assumptions already existing in literature.

SHAPE OPTIMIZATION OF UNDERGROUND EXCAVATION BY SIMULATED ANNEALING

Institute of Geotechnics and Hydrotechnics, Wrocław University of Technology, Wybrzeże Wyspiańskiego 27, 50-370 Wrocław, Poland

Studia Geotechnica et Mechanica

{"article-title":"SHAPE OPTIMIZATION OF UNDERGROUND EXCAVATION BY SIMULATED ANNEALING"}

The paper deals with the problem of shape optimization of underground tunnel excavation. In the pioneering work of Sałustowicz, the elliptic shape was assumed...

SHAPE OPTIMIZATION OF UNDERGROUND EXCAVATION BY SIMULATED ANNEALING

Data publikacji: 14 lut 2014

Zakres stron: 209 - 218

DOI: https://doi.org/10.2478/sgem-2013-0016

This content is open access.