<abstract xmlns="http://www.w3.org/1999/xhtml">

<p>The purpose of this paper is to demonstrate the difference between the ways in which technology can be used to reduce manufacturing time, increasing quality and productivity at the same time. All this has results in a saving of energy, labor and resources in general.</p>
</abstract>

The purpose of this paper is to demonstrate the difference between the ways in which technology can be used to reduce manufacturing time, increasing quality and productivity at the same time. All this has results in a saving of energy, labor and resources in general.

Employng Reworking Areas to Reduce the Cost

“Gheorghe Asachi” Technical University of Iaşi

Bulletin of the Polytechnic Institute of Iași. Machine constructions Section

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.

{"article-title":"Employng Reworking Areas to Reduce the Cost"}

The purpose of this paper is to demonstrate the difference between the ways in which technology can be used to reduce manufacturing time, increasing quality...

Employng Reworking Areas to Reduce the Cost

Data publikacji: 10 lut 2023

Zakres stron: 101 - 104

Otrzymano: 23 gru 2022

Przyjęty: 30 gru 2022

DOI: https://doi.org/10.2478/bipcm-2022-0039

Słowa kluczowe
productivity, manufacturing, quality, rework areas

© 2022 Bruno Rădulescu et al., published by Sciendo

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.

Employng Reworking Areas to Reduce the Cost

Data publikacji: 10 lut 2023

Zakres stron: 101 - 104

Otrzymano: 23 gru 2022

Przyjęty: 30 gru 2022

DOI: https://doi.org/10.2478/bipcm-2022-0039

Słowa kluczoweproductivity, manufacturing, quality, rework areas

© 2022 Bruno Rădulescu et al., published by Sciendo

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.

Słowa kluczowe
productivity, manufacturing, quality, rework areas