<abstract xmlns="http://www.w3.org/1999/xhtml">

<p>The purpose of this paper is to demonstrate the difference between the ways in which technology can be used to reduce manufacturing time, increasing quality and productivity at the same time. All this has results in a saving of energy, labor and resources in general.</p>
</abstract>

The purpose of this paper is to demonstrate the difference between the ways in which technology can be used to reduce manufacturing time, increasing quality and productivity at the same time. All this has results in a saving of energy, labor and resources in general.

Employng Reworking Areas to Reduce the Cost

“Gheorghe Asachi” Technical University of Iaşi

Bulletin of the Polytechnic Institute of Iași. Machine constructions Section

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.

{"article-title":"Employng Reworking Areas to Reduce the Cost"}

The purpose of this paper is to demonstrate the difference between the ways in which technology can be used to reduce manufacturing time, increasing quality...

Employng Reworking Areas to Reduce the Cost

Publié en ligne: 10 févr. 2023

Pages: 101 - 104

Reçu: 23 déc. 2022

Accepté: 30 déc. 2022

DOI: https://doi.org/10.2478/bipcm-2022-0039

Mots clés
productivity, manufacturing, quality, rework areas

© 2022 Bruno Rădulescu et al., published by Sciendo

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.

Employng Reworking Areas to Reduce the Cost

Publié en ligne: 10 févr. 2023

Pages: 101 - 104

Reçu: 23 déc. 2022

Accepté: 30 déc. 2022

DOI: https://doi.org/10.2478/bipcm-2022-0039

Mots clésproductivity, manufacturing, quality, rework areas

© 2022 Bruno Rădulescu et al., published by Sciendo

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.

Mots clés
productivity, manufacturing, quality, rework areas