<abstract xmlns="http://www.w3.org/1999/xhtml">

<p>We optimise the speed gears in a tractor transmission with KISSsoft software under three constraints: input power torque, transmission system volume and the gear ratio for each speed. This study aimed to optimise the module, face width, gear quality, centre distance, number of teeth, helix angle, addendum modification coefficient and pressure angle for each speed while considering the above constraints based on an optimisation chart. Tooth bending stress, tooth contact stress, contact ratio and specific sliding were considered during optimisation. Additionally, the effects of changes in a module on the gear profiles, overlap ratio, number of teeth and weight of the gear pair were examined. Strength calculations of gear pairs that were optimised and defined for all geometric parameters with KISSsoft were calculated with the mathematical model described in ISO 6336, and results were then compared. Finally, backlash was minimised for all gear pairs as defined with geometric parameters, and all dimensions and tolerances were determined for gear inspection after manufacturing. A concept design was also presented. We conclude that both the KISSsoft results and mathematical model results are within the range of the target value.</p>
</abstract>

We optimise the speed gears in a tractor transmission with KISSsoft software under three constraints: input power torque, transmission system volume and the gear ratio for each speed. This study aimed to optimise the module, face width, gear quality, centre distance, number of teeth, helix angle, addendum modification coefficient and pressure angle for each speed while considering the above constraints based on an optimisation chart. Tooth bending stress, tooth contact stress, contact ratio and specific sliding were considered during optimisation. Additionally, the effects of changes in a module on the gear profiles, overlap ratio, number of teeth and weight of the gear pair were examined. Strength calculations of gear pairs that were optimised and defined for all geometric parameters with KISSsoft were calculated with the mathematical model described in ISO 6336, and results were then compared. Finally, backlash was minimised for all gear pairs as defined with geometric parameters, and all dimensions and tolerances were determined for gear inspection after manufacturing. A concept design was also presented. We conclude that both the KISSsoft results and mathematical model results are within the range of the target value.

Optimising the Geometric Parameters of a Gear in a Tractor Transmission Under Constraints Using Kisssoft

Acta Mechanica et Automatica

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

We optimise the speed gears in a tractor transmission with KISSsoft software under three constraints: input power torque, transmission system volume and the...

Optimising the Geometric Parameters of a Gear in a Tractor Transmission Under Constraints Using Kisssoft

Data publikacji: 19 mar 2023

Zakres stron: 145 - 159

Otrzymano: 15 lip 2022

Przyjęty: 13 lis 2022

DOI: https://doi.org/10.2478/ama-2023-0016

Słowa kluczowe
gears, geometric parameters, optimisation, KISSsoft

© 2023 Emre Can et al., published by Sciendo

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Optimising the Geometric Parameters of a Gear in a Tractor Transmission Under Constraints Using Kisssoft

Data publikacji: 19 mar 2023

Zakres stron: 145 - 159

Otrzymano: 15 lip 2022

Przyjęty: 13 lis 2022

DOI: https://doi.org/10.2478/ama-2023-0016

Słowa kluczowegears, geometric parameters, optimisation, KISSsoft

© 2023 Emre Can et al., published by Sciendo

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Słowa kluczowe
gears, geometric parameters, optimisation, KISSsoft