A Small-Sized Robot Prototype Development Using 3D Printing
Igor Nevliudov
Faculty of Automatics and Computerized Technologies, Department of Computer-Integrated Technologies, Automation and Robotics, Ukraine, Kharkiv National University of RadioelectronicsKharkiv, Ukraine
Profil OrcidRecherchez cet auteur sur
, Vladyslav Yevsieiev
Faculty of Automatics and Computerized Technologies, Department of Computer-Integrated Technologies, Automation and Robotics, Ukraine, Kharkiv National University of RadioelectronicsKharkiv, Ukraine
Profil OrcidRecherchez cet auteur sur
, Svitlana Maksymova
Faculty of Automatics and Computerized Technologies, Department of Computer-Integrated Technologies, Automation and Robotics, Ukraine, Kharkiv National University of RadioelectronicsKharkiv, Ukraine
Profil OrcidRecherchez cet auteur sur
et Olena Chala
Faculty of Automatics and Computerized Technologies, Department of Computer-Integrated Technologies, Automation and Robotics, Ukraine, Kharkiv National University of RadioelectronicsKharkiv, Ukraine
Profil OrcidRecherchez cet auteur sur
31 mars 2025
À propos de cet article
Publié en ligne: 31 mars 2025
Pages: 77 - 81
Reçu: 26 janv. 2024
Accepté: 30 oct. 2024
DOI: https://doi.org/10.2478/ama-2025-0010
Mots clés
© 2025 Igor Nevliudov et al., published by Sciendo
This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.
Fig. 1.
Fig. 2.
Fig. 3.
Fig. 4.
Fig. 5.
Fig. 6.
![Microcontroller modules a) ESP32-CAM [7], b) OpenMV Cam H7 R2 [8], c) Raspberry Pi Zero W [9]](https://sciendo-parsed.s3.eu-central-1.amazonaws.com/67f3415f8d1bec042eac83d9/j_ama-2025-0010_fig_006.jpg?X-Amz-Algorithm=AWS4-HMAC-SHA256&X-Amz-Content-Sha256=UNSIGNED-PAYLOAD&X-Amz-Credential=AKIA6AP2G7AKOUXAVR44%2F20250910%2Feu-central-1%2Fs3%2Faws4_request&X-Amz-Date=20250910T200236Z&X-Amz-Expires=3600&X-Amz-Signature=5a68bcd93b86a45d3f493166ca7dbb30404158c57e655e67c752c58ffcdd0909&X-Amz-SignedHeaders=host&x-amz-checksum-mode=ENABLED&x-id=GetObject)
Fig. 7.
Fig. 8.
Fig. 9.
Obtained 3D printing results
Results of testing the operating time of a mobile robot and finding the distance of a stable control signal with streaming video transmission
| Test results (without additional antenna) | |
| Continuous operation time | ~ 15 hours |
| Video stream transmission (open area) | ~ 50–70 meters |
| Video stream transmission (reinforced concrete structure) | ~ 35–55 meters |
| Test results (with additional antenna) | |
| Continuous operation time | ~ 15 hours |
| Video stream transmission (open area) | ~ 170–200 meters |
| Video stream transmission (reinforced concrete structure) | ~ 100–150 meters |