Verification of the Measurement System in a Production Organization
Miroslav Prístavka
Institute of Design and Engineering Technologies, Slovak University of Agriculture in NitraSlovakia
Orcid profileSearch for this author on
, Pavol Findura
Institute of Agricultural Engineering, Transport and Bioenergetics, Slovak University of Agriculture in NitraSlovakia
Orcid profileSearch for this author on
, Ivan Beloev
Department of Transport, Faculty of Transport, University of RuseRuse, Bulgaria
Orcid profileSearch for this author on
, Maciej Kuboń
- Department of Production Engineering, Logistics and Applied Computer Science, Faculty of Production and Power Engineering, University of Agriculture in KrakówPoland
- Eastern European State College of Higher Education in PrzemyślPoland
Orcid profileSearch for this author on
, Veronika Hrdá
Institute of Economics and Management, Slovak University of Agriculture in NitraNitra, Slovakia
Orcid profileSearch for this author on
, and Jun 06, 2022
About this article
Published Online: Jun 06, 2022
Page range: 81 - 90
Received: Mar 01, 2022
Accepted: May 01, 2022
DOI: https://doi.org/10.2478/agriceng-2022-0007
Keywords
© 2022 Miroslav Prístavka et al., published by Sciendo
This work is licensed under the Creative Commons Attribution 4.0 International License.
Monitoring the accuracy of meters by qualified workers and managers is a preventive measure of every organization. The paper focuses on monitoring the accuracy of measuring devices and proposes preventive and corrective actions. The discussed measurement device was tested for accuracy using accuracy indexes Cg and Cgk. The identified deviations in measurements showed that the meter was not fully efficient. Consequently, actions were taken to ensuring that the measurement device is accurate.