<abstract xmlns="http://www.w3.org/1999/xhtml"><p>The paper presents a method and results of breaking of samples that undergo elongation, printed in the FDM (<italic>Fused Deposition Modelling</italic>) technology including various height of a layer. A method of description of the FDM print was described. A developed methodology of research was presented − it was analogous to the research on breaking steel samples. The aim of the research was investigation of the height of a single layer of print on the strength parameters of the produced object. The studies on samples printed with two types of filling were made. The obtained results were set and compared. Based on the research that was carried out, it may be concluded that the tensile strength of samples made in the FDM print technology is proportional to the thickness of a single layer of print.</p></abstract>

The paper presents a method and results of breaking of samples that undergo elongation, printed in the FDM (Fused Deposition Modelling) technology including various height of a layer. A method of description of the FDM print was described. A developed methodology of research was presented − it was analogous to the research on breaking steel samples. The aim of the research was investigation of the height of a single layer of print on the strength parameters of the produced object. The studies on samples printed with two types of filling were made. The obtained results were set and compared. Based on the research that was carried out, it may be concluded that the tensile strength of samples made in the FDM print technology is proportional to the thickness of a single layer of print.

Influence of the Print Layer Height in FDM Technology on the Rolling Force Value and the Print Time

Department of Mechanics and Basics of Machine Construction

University of Warmia and Mazury in Olsztyn

Agricultural Engineering

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

The paper presents a method and results of breaking of samples that undergo elongation, printed in the FDM (Fused Deposition Modelling) technology including...

Influence of the Print Layer Height in FDM Technology on the Rolling Force Value and the Print Time

Published Online: Dec 31, 2019

Page range: 1 - 9

Received: Sep 01, 2019

Accepted: Dec 01, 2019

DOI: https://doi.org/10.1515/agriceng-2019-0031

Keywords
3d printer, FDM, layer height, breaking strength

© 2019 Wojciech Kiński et al., published by Sciendo

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Influence of the Print Layer Height in FDM Technology on the Rolling Force Value and the Print Time

Published Online: Dec 31, 2019

Page range: 1 - 9

Received: Sep 01, 2019

Accepted: Dec 01, 2019

DOI: https://doi.org/10.1515/agriceng-2019-0031

Keywords3d printer, FDM, layer height, breaking strength

© 2019 Wojciech Kiński et al., published by Sciendo

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Keywords
3d printer, FDM, layer height, breaking strength