<abstract xmlns="http://www.w3.org/1999/xhtml"><p>The paper presents a method and results of breaking of samples that undergo elongation, printed in the FDM (<italic>Fused Deposition Modelling</italic>) technology including various height of a layer. A method of description of the FDM print was described. A developed methodology of research was presented − it was analogous to the research on breaking steel samples. The aim of the research was investigation of the height of a single layer of print on the strength parameters of the produced object. The studies on samples printed with two types of filling were made. The obtained results were set and compared. Based on the research that was carried out, it may be concluded that the tensile strength of samples made in the FDM print technology is proportional to the thickness of a single layer of print.</p></abstract>

The paper presents a method and results of breaking of samples that undergo elongation, printed in the FDM (Fused Deposition Modelling) technology including various height of a layer. A method of description of the FDM print was described. A developed methodology of research was presented − it was analogous to the research on breaking steel samples. The aim of the research was investigation of the height of a single layer of print on the strength parameters of the produced object. The studies on samples printed with two types of filling were made. The obtained results were set and compared. Based on the research that was carried out, it may be concluded that the tensile strength of samples made in the FDM print technology is proportional to the thickness of a single layer of print.

Influence of the Print Layer Height in FDM Technology on the Rolling Force Value and the Print Time

Department of Mechanics and Basics of Machine Construction

University of Warmia and Mazury in Olsztyn

Agricultural Engineering

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

The paper presents a method and results of breaking of samples that undergo elongation, printed in the FDM (Fused Deposition Modelling) technology including...

Influence of the Print Layer Height in FDM Technology on the Rolling Force Value and the Print Time

Publié en ligne: 31 déc. 2019

Pages: 1 - 9

Reçu: 01 sept. 2019

Accepté: 01 déc. 2019

DOI: https://doi.org/10.1515/agriceng-2019-0031

Mots clés
3d printer, FDM, layer height, breaking strength

© 2019 Wojciech Kiński et al., published by Sciendo

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Influence of the Print Layer Height in FDM Technology on the Rolling Force Value and the Print Time

Publié en ligne: 31 déc. 2019

Pages: 1 - 9

Reçu: 01 sept. 2019

Accepté: 01 déc. 2019

DOI: https://doi.org/10.1515/agriceng-2019-0031

Mots clés3d printer, FDM, layer height, breaking strength

© 2019 Wojciech Kiński et al., published by Sciendo

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Mots clés
3d printer, FDM, layer height, breaking strength