<abstract xmlns="http://www.w3.org/1999/xhtml">The article presents the results of laboratory tests, the aim of which was to measure cutting forces during parallel turning of an ams 5643 steel bar. The cutting trials were registered with a 3-axis Kisler 9257b piezoelectric dynamometer, and the DynoWare computer program was used to archive and analyse the results. The experimental test plan for variable cutting parameters (<italic>v</italic><italic>c</italic>, <italic>a</italic><italic>p</italic>, <italic>f</italic>) was created according to the Taguchi method and the statistical analysis of the results was performed using anOva. The work involved carrying out 9 tests with the use of an uncoated carbide cutting insert. The obtained test results will be used to specify a simulation model of the cutting process.</abstract>

The article presents the results of laboratory tests, the aim of which was to measure cutting forces during parallel turning of an ams 5643 steel bar. The cutting trials were registered with a 3-axis Kisler 9257b piezoelectric dynamometer, and the DynoWare computer program was used to archive and analyse the results. The experimental test plan for variable cutting parameters (vc, ap, f) was created according to the Taguchi method and the statistical analysis of the results was performed using anOva. The work involved carrying out 9 tests with the use of an uncoated carbide cutting insert. The obtained test results will be used to specify a simulation model of the cutting process.

Experimental determination of forces in a cutting zone durging turning a stainless steel shaft

Institute of Production Engineering, Faculty of Mechanical Engineering

Technical Transactions

This work is licensed under the Creative Commons Attribution-ShareAlike 4.0 Public License.

The article presents the results of laboratory tests, the aim of which was to measure cutting forces during parallel turning of an ams 5643 steel bar. The...

Experimental determination of forces in a cutting zone durging turning a stainless steel shaft

Data publikacji: 21 maj 2020

Zakres stron: 177 - 188

Otrzymano: 03 sie 2018

DOI: https://doi.org/10.4467/2353737XCT.18.124.8899

Słowa kluczowe
stainless steel, cutting forces, ANOVA

© 2019 Łukasz Ślusarczyk et al., published by Sciendo

This work is licensed under the Creative Commons Attribution-ShareAlike 4.0 Public License.

Experimental determination of forces in a cutting zone durging turning a stainless steel shaft

Data publikacji: 21 maj 2020

Zakres stron: 177 - 188

Otrzymano: 03 sie 2018

DOI: https://doi.org/10.4467/2353737XCT.18.124.8899

Słowa kluczowestainless steel, cutting forces, ANOVA

© 2019 Łukasz Ślusarczyk et al., published by Sciendo

This work is licensed under the Creative Commons Attribution-ShareAlike 4.0 Public License.

Słowa kluczowe
stainless steel, cutting forces, ANOVA