<abstract xmlns="http://www.w3.org/1999/xhtml"><p>Knowledge of the dynamic properties of a machine tool–holder–workpiece system is crucial for the appropriate selection of machining parameters based on stability lobes. One of the most convenient methods allowing for the experimental identification of these properties is impact testing. However, the repeatability of such measurements may be different depending on the machine–workpiece setup and can lead to incorrect cutting parameter calculations. The article presents this issue on the example of a lathe-workpiece system. The experimental setup and obtained measurement results are presented and discussed.</p></abstract>

Knowledge of the dynamic properties of a machine tool–holder–workpiece system is crucial for the appropriate selection of machining parameters based on stability lobes. One of the most convenient methods allowing for the experimental identification of these properties is impact testing. However, the repeatability of such measurements may be different depending on the machine–workpiece setup and can lead to incorrect cutting parameter calculations. The article presents this issue on the example of a lathe-workpiece system. The experimental setup and obtained measurement results are presented and discussed.

The Dynamic Repeatability of a Machine Tool–Holder–Workpiece System

Institute of Mechanical Technology, Faculty of Mechanical Engineering and Mechatronics

Technical Transactions

This work is licensed under the Creative Commons Attribution-ShareAlike 4.0 Public License.

{"article-title":"The Dynamic Repeatability of a Machine Tool\u2013Holder\u2013Workpiece System"}

Knowledge of the dynamic properties of a machine tool–holder–workpiece system is crucial for the appropriate selection of machining parameters based on...

The Dynamic Repeatability of a Machine Tool–Holder–Workpiece System

Data publikacji: 16 maj 2020

Zakres stron: 177 - 185

Otrzymano: 20 gru 2017

DOI: https://doi.org/10.4467/2353737XCT.18.014.7965

Słowa kluczowe
machining stability, turning, impact testing, dynamic repeatability

© 2020 Marcin Jasiewicz, published by Sciendo

This work is licensed under the Creative Commons Attribution-ShareAlike 4.0 Public License.

The Dynamic Repeatability of a Machine Tool–Holder–Workpiece System

Data publikacji: 16 maj 2020

Zakres stron: 177 - 185

Otrzymano: 20 gru 2017

DOI: https://doi.org/10.4467/2353737XCT.18.014.7965

Słowa kluczowemachining stability, turning, impact testing, dynamic repeatability

© 2020 Marcin Jasiewicz, published by Sciendo

This work is licensed under the Creative Commons Attribution-ShareAlike 4.0 Public License.

Słowa kluczowe
machining stability, turning, impact testing, dynamic repeatability