<abstract xml:lang="en" xmlns="http://www.w3.org/1999/xhtml"><p>The calibration of horizontal circles results in a set of discrete correction values. These corrections are obtained in specific circle positions chosen by the size of the calibration step. For further use it is necessary to know the correction values for any location on a horizontal circle; therefore, it is necessary to know the function of the continuous corrections of a horizontal circle. This could be achieved from the measured values by several methods. In the article two methods are presented for determining this function through the approximation of polynomial and trigonometric series.</p></abstract>

The calibration of horizontal circles results in a set of discrete correction values. These corrections are obtained in specific circle positions chosen by the size of the calibration step. For further use it is necessary to know the correction values for any location on a horizontal circle; therefore, it is necessary to know the function of the continuous corrections of a horizontal circle. This could be achieved from the measured values by several methods. In the article two methods are presented for determining this function through the approximation of polynomial and trigonometric series.

Processing of calibration measurements on EZB-3

Department of Surveying, Faculty of Civil Engineering, Slovak University of Technology, Radlinského 13, 813 68, Bratislava, Slovakia

Slovak Journal of Civil Engineering

{"article-title":"Processing of calibration measurements on EZB-3"}

The calibration of horizontal circles results in a set of discrete correction values. These corrections are obtained in specific circle positions chosen by the...

Processing of calibration measurements on EZB-3

Data publikacji: 05 sty 2012

Zakres stron: 18 - 23

DOI: https://doi.org/10.2478/v10189-011-0019-7

Słowa kluczowe
Calibration, correction, polynomial series, trigonometric series

This content is open access.

Processing of calibration measurements on EZB-3

Data publikacji: 05 sty 2012

Zakres stron: 18 - 23

DOI: https://doi.org/10.2478/v10189-011-0019-7

Słowa kluczoweCalibration, correction, polynomial series, trigonometric series

This content is open access.

Słowa kluczowe
Calibration, correction, polynomial series, trigonometric series