<abstract xml:lang="en" xmlns="http://www.w3.org/1999/xhtml"><p>Paper deals with filtering roundness. It presents experimental results measured for roundness turning and cylindrical grinding. Roundness was measured using Prismo Navigator 5 coordinate measuring machine. Evaluation was done by four methods: Minimum zone reference circles (MZCI), Least squares reference circle (LSCI), Minimum circumscribed reference circle (MCCI) and Maximum inscribed reference circle (MICI). The filters used were: Gauss, Spline and no filter.</p></abstract>

Paper deals with filtering roundness. It presents experimental results measured for roundness turning and cylindrical grinding. Roundness was measured using Prismo Navigator 5 coordinate measuring machine. Evaluation was done by four methods: Minimum zone reference circles (MZCI), Least squares reference circle (LSCI), Minimum circumscribed reference circle (MCCI) and Maximum inscribed reference circle (MICI). The filters used were: Gauss, Spline and no filter.

Number of Points for Roundness Measurement - Measured Results Comparison

Institute of Production Technologies, Faculty of Materials Science and Technology in Trnava, Slovak University of Technology in Bratislava, J. Bottu 25, 917 24 Trnava, Slovak Republic

Research Papers Faculty of Materials Science and Technology Slovak University of Technology

{"article-title":"Number of Points for Roundness Measurement - Measured Results Comparison"}

Paper deals with filtering roundness. It presents experimental results measured for roundness turning and cylindrical grinding. Roundness was measured using...

Number of Points for Roundness Measurement - Measured Results Comparison

Data publikacji: 21 wrz 2011

Zakres stron: 19 - 24

DOI: https://doi.org/10.2478/v10186-010-0035-x

Słowa kluczowe
roundness, reference circle, filter, measurement, evaluation methods

This content is open access.

Number of Points for Roundness Measurement - Measured Results Comparison

Data publikacji: 21 wrz 2011

Zakres stron: 19 - 24

DOI: https://doi.org/10.2478/v10186-010-0035-x

Słowa kluczoweroundness, reference circle, filter, measurement, evaluation methods

This content is open access.

Słowa kluczowe
roundness, reference circle, filter, measurement, evaluation methods