<abstract xml:lang="en" xmlns="http://www.w3.org/1999/xhtml">In the first research studies series a selection of the quantitative composition of catalyst active phase composition (iron, copper and manganese) deposited on mineral-carbon support was carried out. It was found on the basis of the selection studies series that the best results were attained when copper and manganese were used as catalyst components. The quantitative composition of the denitrogention catalyst was estimated using a statistical method of experiment planning and metals content changed in the range 0.5 - 1.5wt % for both metals. Catalyst activity in nitric oxide reduction by ammonia was determined in the dependence on an active phase composition in the temperature range 100 - 200°C, at GHSV (Gas Hour Space Velocity) 6 000 and 10 000 Nm3/m3h, NO concentration 400 ppm, NH3/NO ratio 1:1. A graphic presentation of the obtained results was made using the UNIPLOT program. The highest activity in nitric oxide reduction by ammonia presented copper - manganese catalysts prepared by the impregnation of mineral-carbon support with active metals salts solutions and calcination after each metal impregnation with copper (up to 1.5 wt %) and manganese (up to 1.5 wt %).</abstract>

In the first research studies series a selection of the quantitative composition of catalyst active phase composition (iron, copper and manganese) deposited on mineral-carbon support was carried out. It was found on the basis of the selection studies series that the best results were attained when copper and manganese were used as catalyst components. The quantitative composition of the denitrogention catalyst was estimated using a statistical method of experiment planning and metals content changed in the range 0.5 - 1.5wt % for both metals. Catalyst activity in nitric oxide reduction by ammonia was determined in the dependence on an active phase composition in the temperature range 100 - 200°C, at GHSV (Gas Hour Space Velocity) 6 000 and 10 000 Nm3/m3h, NO concentration 400 ppm, NH3/NO ratio 1:1. A graphic presentation of the obtained results was made using the UNIPLOT program. The highest activity in nitric oxide reduction by ammonia presented copper - manganese catalysts prepared by the impregnation of mineral-carbon support with active metals salts solutions and calcination after each metal impregnation with copper (up to 1.5 wt %) and manganese (up to 1.5 wt %).

Optimization of an active phase composition in the low-temperature nitric oxide reduction catalyst

Faculty of Chemistry, Department of Fuels Chemistry and Technology, Wrocław University of Technology, ul. Gdańska 7/9, 50-344 Wrocław, Poland

Polish Journal of Chemical Technology

In the first research studies series a selection of the quantitative composition of catalyst active phase composition (iron, copper and manganese) deposited on...

Optimization of an active phase composition in the low-temperature nitric oxide reduction catalyst

Data publikacji: 06 lis 2007

Zakres stron: 33 - 37

DOI: https://doi.org/10.2478/v10026-007-0049-0

Słowa kluczowe
NO, SCR, catalyst, optimization, mineral-carbon carrier

This content is open access.

Optimization of an active phase composition in the low-temperature nitric oxide reduction catalyst

Data publikacji: 06 lis 2007

Zakres stron: 33 - 37

DOI: https://doi.org/10.2478/v10026-007-0049-0

Słowa kluczoweNO, SCR, catalyst, optimization, mineral-carbon carrier

This content is open access.

Słowa kluczowe
NO, SCR, catalyst, optimization, mineral-carbon carrier