<abstract xmlns="http://www.w3.org/1999/xhtml">

<p>One of the typical sandwich ending is tapered transition to a solid laminate, which causes significant stress distribution changes. The reviewed articles show that tapered area causes increase in the shear stress in the core, increase of the axial forces in the facesheets and local bending at the fork point, at points of the tapering angle change, and at ply drop positions. Most of the studies gave attention to the endings without reinforcing. During Erasmus+ internship at KTH 2D model of the tapered ending with reinforcing plies, various geometry and resin filler in the core tip was investigated to see the influence on the stress distribution. It was found that tension load case is not as critical as bending load case. Increasing of the solid laminate thickness, adding plies and inserting a short resin or adhesive filler into the core tip area lead to significant stress reduction, whereas in the transition point, from tapering to constant thickness sandwich, increasing radius is more efficient than reinforcing plies in regard to reduce stress concentration.</p>
</abstract>

One of the typical sandwich ending is tapered transition to a solid laminate, which causes significant stress distribution changes. The reviewed articles show that tapered area causes increase in the shear stress in the core, increase of the axial forces in the facesheets and local bending at the fork point, at points of the tapering angle change, and at ply drop positions. Most of the studies gave attention to the endings without reinforcing. During Erasmus+ internship at KTH 2D model of the tapered ending with reinforcing plies, various geometry and resin filler in the core tip was investigated to see the influence on the stress distribution. It was found that tension load case is not as critical as bending load case. Increasing of the solid laminate thickness, adding plies and inserting a short resin or adhesive filler into the core tip area lead to significant stress reduction, whereas in the transition point, from tapering to constant thickness sandwich, increasing radius is more efficient than reinforcing plies in regard to reduce stress concentration.

Stress Distribution Investigation at the Tapered Sandwich Endings

Institute of Aerospace Engineering, Faculty of Mechanical Engineering

Transactions on Aerospace Research

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

{"article-title":"Stress Distribution Investigation at the Tapered Sandwich Endings"}

One of the typical sandwich ending is tapered transition to a solid laminate, which causes significant stress distribution changes. The reviewed articles show...

Stress Distribution Investigation at the Tapered Sandwich Endings

Data publikacji: 31 maj 2019

Zakres stron: 64 - 81

DOI: https://doi.org/10.2478/tar-2017-0029

Słowa kluczowe
Sandwich endings, Tapering, Ramp, Closeout, FEM, Filler, Ply drop

© 2017 Copyright by Lukasiewicz Research Network – Institute of Aviation

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Stress Distribution Investigation at the Tapered Sandwich Endings

Data publikacji: 31 maj 2019

Zakres stron: 64 - 81

DOI: https://doi.org/10.2478/tar-2017-0029

Słowa kluczoweSandwich endings, Tapering, Ramp, Closeout, FEM, Filler, Ply drop

© 2017 Copyright by Lukasiewicz Research Network – Institute of Aviation

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Słowa kluczowe
Sandwich endings, Tapering, Ramp, Closeout, FEM, Filler, Ply drop