<abstract xml:lang="en" xmlns="http://www.w3.org/1999/xhtml"><p>Using a set of modern/young (0 to about 200 years old) dust samples collected from the Chinese Loess Plateau the bleachability of IRSL measured at 50°C (IR50) and post-IR50 elevated temperature IRSL (measured at 225°C and at 290°C) is investigated by measuring the apparent (residual) doses recorded by these signals. Doses recorded by quartz OSL are used as a reference. Allowing for differences in dose rates it seems that both IRSL and post-IR IRSL signals yield residual doses that are significantly larger than the doses measured in quartz. These residual doses can be largely explained by thermal transfer caused by preheating. Nevertheless, we advise against the use of a low temperature preheat (&lt;200°C) with IR50 to date loess samples because, as has been reported before, the signal appears to be thermally unstable. In general, we conclude that it may not be advisable to apply post-IR IRSL dating to Chinese loess samples where residuals of up to ∼20 Gy are a significant fraction of the total dose. However, these residuals quickly become unimportant when dating older samples, and this is the age range in which post-IR IRSL dating is likely to be most useful.</p></abstract>

Using a set of modern/young (0 to about 200 years old) dust samples collected from the Chinese Loess Plateau the bleachability of IRSL measured at 50°C (IR50) and post-IR50 elevated temperature IRSL (measured at 225°C and at 290°C) is investigated by measuring the apparent (residual) doses recorded by these signals. Doses recorded by quartz OSL are used as a reference. Allowing for differences in dose rates it seems that both IRSL and post-IR IRSL signals yield residual doses that are significantly larger than the doses measured in quartz. These residual doses can be largely explained by thermal transfer caused by preheating. Nevertheless, we advise against the use of a low temperature preheat (<200°C) with IR50 to date loess samples because, as has been reported before, the signal appears to be thermally unstable. In general, we conclude that it may not be advisable to apply post-IR IRSL dating to Chinese loess samples where residuals of up to ∼20 Gy are a significant fraction of the total dose. However, these residuals quickly become unimportant when dating older samples, and this is the age range in which post-IR IRSL dating is likely to be most useful.

IRSL and post-IR IRSL residual doses recorded in modern dust samples from the Chinese Loess Plateau

Nordic Laboratory for Luminescence Dating, Department of Earth Sciences, Aarhus University, Risø DTU, DK-4000, Roskilde, Denmark

Radiation Research Division, Risø National Laboratory for Sustainable Energy, Technical University of Denmark, DK-4000, Roskilde, Denmark

Leibniz Institute for Applied Geophysics, S3: Geochronology and Isotope Hydrology, 30655, Hannover, Germany

Laboratory of Mineralogy and Petrology, Department of Geology and Soil Science, Ghent University, B-9000, Ghent, Belgium

School of Geographical and Oceanographical Sciences, Nanjing University, Nanjing, 210093, China

Geochronometria

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Using a set of modern/young (0 to about 200 years old) dust samples collected from the Chinese Loess Plateau the bleachability of IRSL measured at 50°C (IR50)...

IRSL and post-IR IRSL residual doses recorded in modern dust samples from the Chinese Loess Plateau

Data publikacji: 22 wrz 2011

Zakres stron: 432 - 440

DOI: https://doi.org/10.2478/s13386-011-0047-0

Słowa kluczowe
modern dust, IRSL, polymineral fine-grains, post-IR IRSL, loess, China

© 2011 Silesian University of Technology, Gliwice, Poland

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

IRSL and post-IR IRSL residual doses recorded in modern dust samples from the Chinese Loess Plateau

Data publikacji: 22 wrz 2011

Zakres stron: 432 - 440

DOI: https://doi.org/10.2478/s13386-011-0047-0

Słowa kluczowemodern dust, IRSL, polymineral fine-grains, post-IR IRSL, loess, China

© 2011 Silesian University of Technology, Gliwice, Poland

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Słowa kluczowe
modern dust, IRSL, polymineral fine-grains, post-IR IRSL, loess, China