<abstract xmlns="http://www.w3.org/1999/xhtml">

<p>This research is dedicated to investigating whether mechanical properties of Ti-6Al-4V (Titanium Grade 5) base material for additive manufacturing processes can be improved by addition of carbon nanotubes in the base material. Based on other research results with other materials, the assumption was made that reinforcing Ti-6Al-4V material with carbon nano-tubes should improve mechanical properties of the base material by 15–20 % in the additive manufacturing process. The research was divided in two steps, the first one was to investigate pure Ti-6Al-4V material and find optimal additive manufacturing processing parameters, which could maintain necessary quality standards and achieve material density levels higher than 98 % and tensile strength higher than 1000 MPa. The second part was to mix base powder with carbon nanotubes and using previously obtained processing parameters print test samples to investigate how a carbon nanotube concentration in a base powder would influence mechanical properties of the base material.</p>
</abstract>

This research is dedicated to investigating whether mechanical properties of Ti-6Al-4V (Titanium Grade 5) base material for additive manufacturing processes can be improved by addition of carbon nanotubes in the base material. Based on other research results with other materials, the assumption was made that reinforcing Ti-6Al-4V material with carbon nano-tubes should improve mechanical properties of the base material by 15–20 % in the additive manufacturing process. The research was divided in two steps, the first one was to investigate pure Ti-6Al-4V material and find optimal additive manufacturing processing parameters, which could maintain necessary quality standards and achieve material density levels higher than 98 % and tensile strength higher than 1000 MPa. The second part was to mix base powder with carbon nanotubes and using previously obtained processing parameters print test samples to investigate how a carbon nanotube concentration in a base powder would influence mechanical properties of the base material.

Additive Manufacturing of Ti-6Al-4V with Carbon Nanotube Composite Material

Latvian Journal of Physics and Technical Sciences

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

{"article-title":"Additive Manufacturing of Ti-6Al-4V with Carbon Nanotube Composite Material"}

This research is dedicated to investigating whether mechanical properties of Ti-6Al-4V (Titanium Grade 5) base material for additive manufacturing processes...

Additive Manufacturing of Ti-6Al-4V with Carbon Nanotube Composite Material

Data publikacji: 30 lis 2023

Zakres stron: 100 - 112

DOI: https://doi.org/10.2478/lpts-2023-0039

Słowa kluczowe
3D printing, additive manufacturing, carbon nanotubes (CNTs), grade 5, tensile strength, Ti-6Al-4V, titanium

© 2023 A. Vevers et al., published by Sciendo

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Additive Manufacturing of Ti-6Al-4V with Carbon Nanotube Composite Material

Data publikacji: 30 lis 2023

Zakres stron: 100 - 112

DOI: https://doi.org/10.2478/lpts-2023-0039

Słowa kluczowe3D printing, additive manufacturing, carbon nanotubes (CNTs), grade 5, tensile strength, Ti-6Al-4V, titanium

© 2023 A. Vevers et al., published by Sciendo

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Słowa kluczowe
3D printing, additive manufacturing, carbon nanotubes (CNTs), grade 5, tensile strength, Ti-6Al-4V, titanium