<abstract xmlns="http://www.w3.org/1999/xhtml"><p>The main goal of the article is to describe the development and production of a prototype of an additional system for wheel motor bearing protection using additive technologies. These technologies include rapid prototyping and vacuum casting. These technologies greatly facilitate and speed up the whole process of developing a new component. Before the development itself, it was necessary to digitize the wheel hub using reverse engineering technology. Using a 3D scanner, a part model was created, based on which an additional system for wheel bearing protection was designed for the CAD system. The dimensional analysis of the produced prototypes was performed. Prototypes of the protection system made of different materials will be tested in common operation conditions.</p></abstract>

The main goal of the article is to describe the development and production of a prototype of an additional system for wheel motor bearing protection using additive technologies. These technologies include rapid prototyping and vacuum casting. These technologies greatly facilitate and speed up the whole process of developing a new component. Before the development itself, it was necessary to digitize the wheel hub using reverse engineering technology. Using a 3D scanner, a part model was created, based on which an additional system for wheel bearing protection was designed for the CAD system. The dimensional analysis of the produced prototypes was performed. Prototypes of the protection system made of different materials will be tested in common operation conditions.

Development of an Additional System for Wheel Bearing Protection

LOGI – Scientific Journal on Transport and Logistics

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

{"article-title":"Development of an Additional System for Wheel Bearing Protection"}

The main goal of the article is to describe the development and production of a prototype of an additional system for wheel motor bearing protection using...

Development of an Additional System for Wheel Bearing Protection

Data publikacji: 26 lis 2020

Zakres stron: 68 - 75

Otrzymano: 08 paź 2020

Przyjęty: 28 paź 2020

DOI: https://doi.org/10.2478/logi-2020-0016

Słowa kluczowe
Bearing protection, additive technologies, prototype, reverse engineering

© 2020 Jan Steininger et al., published by Sciendo

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Development of an Additional System for Wheel Bearing Protection

Data publikacji: 26 lis 2020

Zakres stron: 68 - 75

Otrzymano: 08 paź 2020

Przyjęty: 28 paź 2020

DOI: https://doi.org/10.2478/logi-2020-0016

Słowa kluczoweBearing protection, additive technologies, prototype, reverse engineering

© 2020 Jan Steininger et al., published by Sciendo

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Słowa kluczowe
Bearing protection, additive technologies, prototype, reverse engineering