<abstract xmlns="http://www.w3.org/1999/xhtml">

A novel single-layer metallo-dielectric superstructure is proposed in this paper. It is constructed by two asymmetric unit- cells optimally arranged on the same layer to construct a partially reflective surface to be placed over a multilayer microstrip slot antenna named feed antenna for enhancing its performances. The radiation is expected to be maximum at the center of the formed layer. Thus, to maintain a high-gain performance, the unit-cells placed at the center are designed to provide a quasi-optimal reflection phase with high reflectivity at the frequency band of interest. A prototype of the proposed antenna operating at 10 GHz with overall size of 2.133λ0 ×2.133λ0 ×0.56λ0 is successfully designed and fabricated. The calculated and measured antenna gain results indicate that the proposed antenna exhibits a wider radiation bandwidth performance of about 41.15% and 36.15%, respectively.
</abstract>

A novel single-layer metallo-dielectric superstructure is proposed in this paper. It is constructed by two asymmetric unit- cells optimally arranged on the same layer to construct a partially reflective surface to be placed over a multilayer microstrip slot antenna named feed antenna for enhancing its performances. The radiation is expected to be maximum at the center of the formed layer. Thus, to maintain a high-gain performance, the unit-cells placed at the center are designed to provide a quasi-optimal reflection phase with high reflectivity at the frequency band of interest. A prototype of the proposed antenna operating at 10 GHz with overall size of 2.133λ0 ×2.133λ0 ×0.56λ0 is successfully designed and fabricated. The calculated and measured antenna gain results indicate that the proposed antenna exhibits a wider radiation bandwidth performance of about 41.15% and 36.15%, respectively.

A single-layer metallo-dielectric superstructure for enhancing the performances of EBG cavity antenna

Laboratoire des Télécommunications-LT, Département d’Electronique et Télécommunications, Faculté des Sciences et de la Technologie

King Fahd University of Petroleum and Minerals

Department of Electronics, LIS Laboratory, Faculty of Technology

Journal of Electrical Engineering

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.

A novel single-layer metallo-dielectric superstructure is proposed in this paper. It is constructed by two asymmetric unit- cells optimally arranged on the...

A single-layer metallo-dielectric superstructure for enhancing the performances of EBG cavity antenna

Data publikacji: 18 mar 2021

Zakres stron: 53 - 60

Otrzymano: 04 wrz 2020

DOI: https://doi.org/10.2478/jee-2021-0008

Słowa kluczowe
wideband and high gain performances, wide radiation bandwidth, single layer partially reflective surface (PRS), electromagnetic-band-gap cavity antenna (ECA), equivalent circuit

© 2021 Abdelhalim Chaabane et al., published by Sciendo

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.

A single-layer metallo-dielectric superstructure for enhancing the performances of EBG cavity antenna

Data publikacji: 18 mar 2021

Zakres stron: 53 - 60

Otrzymano: 04 wrz 2020

DOI: https://doi.org/10.2478/jee-2021-0008

Słowa kluczowewideband and high gain performances, wide radiation bandwidth, single layer partially reflective surface (PRS), electromagnetic-band-gap cavity antenna (ECA), equivalent circuit

© 2021 Abdelhalim Chaabane et al., published by Sciendo

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.

Słowa kluczowe
wideband and high gain performances, wide radiation bandwidth, single layer partially reflective surface (PRS), electromagnetic-band-gap cavity antenna (ECA), equivalent circuit