<abstract xmlns="http://www.w3.org/1999/xhtml"><p>This paper presents a design of typical multilayer on-chip inductor to determine the layout parameters of the desired inductance value of electromagnetic modeling. The inductance and quality factor of multilayer on-chip spiral inductors are determined by its layout parameters and technological parameters. These layout parameters must be optimized to obtain the maximum quality factor at the desired frequency of operation. An electromagnetic model with fewer assumptions than empirical equations and higher efficiency than full-field solvers would be welcome. So would facile comparisons of different inductor structures. This paper describes recent works on the electromagnetic modeling of on-chip inductor structures applied to the comparison of inductor geometries, including the traditional spiral inductor and a novel multilayer inductor. The electromagnetic modeling of the investigative model is presented. The modeling and simulation are implemented using the method of moments. To simulate the proposed algorithm, the EM Simulator software is used.</p></abstract>

This paper presents a design of typical multilayer on-chip inductor to determine the layout parameters of the desired inductance value of electromagnetic modeling. The inductance and quality factor of multilayer on-chip spiral inductors are determined by its layout parameters and technological parameters. These layout parameters must be optimized to obtain the maximum quality factor at the desired frequency of operation. An electromagnetic model with fewer assumptions than empirical equations and higher efficiency than full-field solvers would be welcome. So would facile comparisons of different inductor structures. This paper describes recent works on the electromagnetic modeling of on-chip inductor structures applied to the comparison of inductor geometries, including the traditional spiral inductor and a novel multilayer inductor. The electromagnetic modeling of the investigative model is presented. The modeling and simulation are implemented using the method of moments. To simulate the proposed algorithm, the EM Simulator software is used.

Design of a multilayer on-chip inductor by computational electromagnetic modelling

Department of Electronics and Communication Engineering

Journal of Electrical Engineering

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 License.

This paper presents a design of typical multilayer on-chip inductor to determine the layout parameters of the desired inductance value of electromagnetic...

Design of a multilayer on-chip inductor by computational electromagnetic modelling

Data publikacji: 26 lis 2019

Zakres stron: 379 - 385

Otrzymano: 06 cze 2019

DOI: https://doi.org/10.2478/jee-2019-0069

Słowa kluczowe
inductor, electromagnetic modeling, quality factor, mutual inductance, method of moments

© 2019 Muneeswaran Dhamodaran et al., published by Sciendo

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 License.

Design of a multilayer on-chip inductor by computational electromagnetic modelling

Data publikacji: 26 lis 2019

Zakres stron: 379 - 385

Otrzymano: 06 cze 2019

DOI: https://doi.org/10.2478/jee-2019-0069

Słowa kluczoweinductor, electromagnetic modeling, quality factor, mutual inductance, method of moments

© 2019 Muneeswaran Dhamodaran et al., published by Sciendo

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 License.

Słowa kluczowe
inductor, electromagnetic modeling, quality factor, mutual inductance, method of moments