Logowanie
Zarejestruj się
Zresetuj hasło
Publikuj i Dystrybuuj
Rozwiązania Wydawnicze
Rozwiązania Dystrybucyjne
Dziedziny
Architektura i projektowanie
Bibliotekoznawstwo i bibliologia
Biznes i ekonomia
Chemia
Chemia przemysłowa
Filozofia
Fizyka
Historia
Informatyka
Inżynieria
Inżynieria materiałowa
Językoznawstwo i semiotyka
Kulturoznawstwo
Literatura
Matematyka
Medycyna
Muzyka
Nauki farmaceutyczne
Nauki klasyczne i starożytne studia bliskowschodnie
Nauki o Ziemi
Nauki o organizmach żywych
Nauki społeczne
Prawo
Sport i rekreacja
Studia judaistyczne
Sztuka
Teologia i religia
Zagadnienia ogólne
Publikacje
Czasopisma
Książki
Materiały konferencyjne
Wydawcy
Blog
Kontakt
Wyszukiwanie
EUR
USD
GBP
Polski
English
Deutsch
Polski
Español
Français
Italiano
Koszyk
Home
Czasopisma
Gravitational and Space Research
Tom 5 (2017): Zeszyt 1 (July 2017)
Otwarty dostęp
Injecting a Liquid in Weightlessness: Droplet or Geyser Formation
Steven H. Collicott
Steven H. Collicott
oraz
Kyle D. Kennedy
Kyle D. Kennedy
| 20 lip 2020
Gravitational and Space Research
Tom 5 (2017): Zeszyt 1 (July 2017)
O artykule
Poprzedni artykuł
Następny artykuł
Abstrakt
Artykuł
Ilustracje i tabele
Referencje
Autorzy
Artykuły w tym zeszycie
Podgląd
PDF
Zacytuj
Udostępnij
Article Category:
Research Article
Data publikacji:
20 lip 2020
Zakres stron:
35 - 40
DOI:
https://doi.org/10.2478/gsr-2017-0003
Słowa kluczowe
Droplet Formation
,
Liquid Injection
,
Fluid Dynamics
© 2017 Steven H. Collicott et al., published by Sciendo
This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.
Figure 1
Droplet and geyser geometries – light gray is the liquid, dark gray is the solid. White background is the air. Sharp orifice rims are shown here; see below for the bluntness types examined in the present research.
Figure 2
Droplet (left) and geyser (right) images from flight test of 0.48 cm diameter orifices (the two images are presented at the same scale). The small droplets in the foreground of the right image are residues of a test during a previous parabola and are in the fields of view but are not interacting with the hole or the jet.
Figure 3
Injection hole edge conditions. In this geometry, the liquid flow, when present, was upwards from the hole.
Figure 4
Photograph of experiment bolted to the floor on board the 727 of the Zero-G Corporation. The transparent box in the left half of the frame is the second level of containment around the test sections.
Figure 5
Experiment components, initial condition. One fluid system is shown in this view; there are two additional systems, identical except for the orifice size or rim shape, behind this system.
Figure 6
All of the data from four holes over two flights.