<abstract xmlns="http://www.w3.org/1999/xhtml">

<p>Research into the possibility of applying the electric impedance spectrometry (EIS) method and the dielectric capacitance method (DECM) simultaneously above fibre saturation point (FSP) and in harsh kiln conditions has been relatively scarce. In the framework of this research, tests were carried out on the operational reliability of the measuring capacitor (MEC) prototype used for calibrating the DECM in the harsh internal climate (50°C and 98% RH) of the kiln. Condensation of water vapor on MEC plates, leakage of MEC insulators and the emergence of static electric charges on MEC plates were studied. Quantitative ranges were found for MEC performance-disrupting effects on the parasitic capacities induced by each effect. The DECM was found to be less reliable than the EIS method for application in harsh kiln conditions. Secondly, under the same test conditions and for the same wood species (birch), the possibilities of the DECM method and the EIS method were comparatively modeled with the predetermined Rozema quality criterion of ±1.75% MC for predicting the moisture content (MC) of birch wood above FSP. It was found that, under the same test conditions, the DECM method proved more accurate than the EIS method for predicting birch wood MC above FSP. Based on the tests, it was concluded that DECM can be used in practice by applying a non-destructive method to reliably determine the average moisture content of a wood batch immediately prior to commencing the wood-drying process.</p>
</abstract>

Research into the possibility of applying the electric impedance spectrometry (EIS) method and the dielectric capacitance method (DECM) simultaneously above fibre saturation point (FSP) and in harsh kiln conditions has been relatively scarce. In the framework of this research, tests were carried out on the operational reliability of the measuring capacitor (MEC) prototype used for calibrating the DECM in the harsh internal climate (50°C and 98% RH) of the kiln. Condensation of water vapor on MEC plates, leakage of MEC insulators and the emergence of static electric charges on MEC plates were studied. Quantitative ranges were found for MEC performance-disrupting effects on the parasitic capacities induced by each effect. The DECM was found to be less reliable than the EIS method for application in harsh kiln conditions. Secondly, under the same test conditions and for the same wood species (birch), the possibilities of the DECM method and the EIS method were comparatively modeled with the predetermined Rozema quality criterion of ±1.75% MC for predicting the moisture content (MC) of birch wood above FSP. It was found that, under the same test conditions, the DECM method proved more accurate than the EIS method for predicting birch wood MC above FSP. Based on the tests, it was concluded that DECM can be used in practice by applying a non-destructive method to reliably determine the average moisture content of a wood batch immediately prior to commencing the wood-drying process.

Comparative testing of two alternating current methods for determining wood moisture content in kiln conditions

Forestry Studies

This work is licensed under the Creative Commons Attribution 4.0 International License.

Puidu niiskussisalduse määramise kahe vahelduvvoolu meetodi katsetamine puidukuivati tingimustes

Research into the possibility of applying the electric impedance spectrometry (EIS) method and the dielectric capacitance method (DECM) simultaneously above...

Comparative testing of two alternating current methods for determining wood moisture content in kiln conditions

Article Category: Research paper

Data publikacji: 01 gru 2021

Zakres stron: 72 - 87

Otrzymano: 23 sie 2021

Przyjęty: 04 paź 2021

DOI: https://doi.org/10.2478/fsmu-2021-0005

© 2021 by the authors., published by Sciendo

This work is licensed under the Creative Commons Attribution 4.0 International License.