<abstract xmlns="http://www.w3.org/1999/xhtml">

Being known the lack of information about constants that appear in the Kienzle relationship, this work proposes a solution to reduce the effort required to customize their values.
Applied to face milling, the proposed procedure makes it possible to identify the coefficients in the case of turning, using experiments under certain conditions of similarity, which are then used to calculate the principal cutting force in the case of milling.
The proposed procedure uses a stationary dynamometer both to measure the cutting force in the case of turning and to calculate the tangential force in the case of face milling.
The experiments carried out have tried to simulate a real processing case for industry, the worpiece material being used as supplied by the supplier.
</abstract>

Being known the lack of information about constants that appear in the Kienzle relationship, this work proposes a solution to reduce the effort required to customize their values.
Applied to face milling, the proposed procedure makes it possible to identify the coefficients in the case of turning, using experiments under certain conditions of similarity, which are then used to calculate the principal cutting force in the case of milling.
The proposed procedure uses a stationary dynamometer both to measure the cutting force in the case of turning and to calculate the tangential force in the case of face milling.
The experiments carried out have tried to simulate a real processing case for industry, the worpiece material being used as supplied by the supplier.

An Empirical Estimation of Cutting Force for Face Milling Using a Stationary Dynamometer

“Gheorghe Asachi” Technical University of Iaşi

Bulletin of the Polytechnic Institute of Iași. Machine constructions Section

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.

Being known the lack of information about constants that appear in the Kienzle relationship, this work proposes a solution to reduce the effort required to...

An Empirical Estimation of Cutting Force for Face Milling Using a Stationary Dynamometer

Data publikacji: 23 lut 2022

Zakres stron: 53 - 67

Otrzymano: 30 lis 2021

Przyjęty: 14 gru 2021

DOI: https://doi.org/10.2478/bipcm-2021-0023

Słowa kluczowe
specific cutting force, single cutting milling face, stationary dynamometer, cutting force coefficients, dry machining

© 2021 Cristian Croitoru, published by Sciendo

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.

An Empirical Estimation of Cutting Force for Face Milling Using a Stationary Dynamometer

Data publikacji: 23 lut 2022

Zakres stron: 53 - 67

Otrzymano: 30 lis 2021

Przyjęty: 14 gru 2021

DOI: https://doi.org/10.2478/bipcm-2021-0023

Słowa kluczowespecific cutting force, single cutting milling face, stationary dynamometer, cutting force coefficients, dry machining

© 2021 Cristian Croitoru, published by Sciendo

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.

Słowa kluczowe
specific cutting force, single cutting milling face, stationary dynamometer, cutting force coefficients, dry machining