<abstract xmlns="http://www.w3.org/1999/xhtml">

<p>Electrodynamic sensors are used in the process industry because they are low cost and robust. Though frequently used very little fundamental work on them has been reported. This paper describes an investigation into characteristics of hemispherically and rectangularly shaped sensors. Two parameters are investigated, the effect of sensor area on sensitivity and the spatial filtering effect of the sensor due to its finite size. Models are proposed and results obtained using them compared with experimental values.</p>
</abstract>

Electrodynamic sensors are used in the process industry because they are low cost and robust. Though frequently used very little fundamental work on them has been reported. This paper describes an investigation into characteristics of hemispherically and rectangularly shaped sensors. Two parameters are investigated, the effect of sensor area on sensitivity and the spatial filtering effect of the sensor due to its finite size. Models are proposed and results obtained using them compared with experimental values.

An electrodynamic sensor for electrostatic charge measurement

Faculty of Electrical Engineering, Universiti Teknologi Malaysia

International Journal on Smart Sensing and Intelligent Systems

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.

{"article-title":"An electrodynamic sensor for electrostatic charge measurement"}

Electrodynamic sensors are used in the process industry because they are low cost and robust. Though frequently used very little fundamental work on them has...

An electrodynamic sensor for electrostatic charge measurement

Data publikacji: 02 lis 2017

Zakres stron: 200 - 212

DOI: https://doi.org/10.21307/ijssis-2017-346

© 2009 M. F. Rahmat et al., published by Sciendo

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.