<abstract xmlns="http://www.w3.org/1999/xhtml"><p>In this work we studied the influence of the fluid injection configuration (OIG: outside-in-gas, OIL: outside-in-liquid) on the internal flows and external sprays parameters. We sprayed the viscous aqueous maltodextrin solutions (μ = 60 mPa·s) at a constant inlet pressure of the gas and the gas to the liquid mass flow ratio (GLR) within the range 2.5 to 20%. We found that the fluids injection has a crucial influence on the internal flows. The internal flows patterns for the OIG atomizer were the slug flows, the internal flow of the OIL device was annular which led to the significant improvement of the spray quality: Smaller droplets, faster atomization, fewer pulsations.</p></abstract>

In this work we studied the influence of the fluid injection configuration (OIG: outside-in-gas, OIL: outside-in-liquid) on the internal flows and external sprays parameters. We sprayed the viscous aqueous maltodextrin solutions (μ = 60 mPa·s) at a constant inlet pressure of the gas and the gas to the liquid mass flow ratio (GLR) within the range 2.5 to 20%. We found that the fluids injection has a crucial influence on the internal flows. The internal flows patterns for the OIG atomizer were the slug flows, the internal flow of the OIL device was annular which led to the significant improvement of the spray quality: Smaller droplets, faster atomization, fewer pulsations.

Comparison of the Viscous Liquids Spraying by the OIG and the Oil Configurations of an Effervescent Atomizer at Low Inlet Pressures

Slovak University of Technology in Bratislava, Faculty of Mechanical Engineering, Institute of of Energy Machinery, Nám. Slobody 17, 812 31 Bratislava, Slovakia

Strojnícky časopis - Journal of Mechanical Engineering

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

In this work we studied the influence of the fluid injection configuration (OIG: outside-in-gas, OIL: outside-in-liquid) on the internal flows and external...

Comparison of the Viscous Liquids Spraying by the OIG and the Oil Configurations of an Effervescent Atomizer at Low Inlet Pressures

Data publikacji: 19 sie 2016

Zakres stron: 53 - 64

DOI: https://doi.org/10.1515/scjme-2016-0011

Słowa kluczowe
effervescent atomizer, OIL atomizer, OIL atomizer, flow visualization, CFD, droplet sizing, sprays

© 2016 Mlkvik Marek et al., published by De Gruyter Open

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Comparison of the Viscous Liquids Spraying by the OIG and the Oil Configurations of an Effervescent Atomizer at Low Inlet Pressures

Data publikacji: 19 sie 2016

Zakres stron: 53 - 64

DOI: https://doi.org/10.1515/scjme-2016-0011

Słowa kluczoweeffervescent atomizer, OIL atomizer, OIL atomizer, flow visualization, CFD, droplet sizing, sprays

© 2016 Mlkvik Marek et al., published by De Gruyter Open

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Słowa kluczowe
effervescent atomizer, OIL atomizer, OIL atomizer, flow visualization, CFD, droplet sizing, sprays