<abstract xmlns="http://www.w3.org/1999/xhtml"><p>This paper deals with the use of the numerical computer oriented method for the analysis and verification of the design of workpiece clamping. The inaccuracies of the positioning in clamping locating points were simulated using the FEM software ANSYS. The influence of inaccuracies in the positions of contact locating points on the displacements of the workpiece characteristic points and their position in clamped removable jaws was examined. The reaction forces in the contact locating points were also computed and analyzed.</p></abstract>

This paper deals with the use of the numerical computer oriented method for the analysis and verification of the design of workpiece clamping. The inaccuracies of the positioning in clamping locating points were simulated using the FEM software ANSYS. The influence of inaccuracies in the positions of contact locating points on the displacements of the workpiece characteristic points and their position in clamped removable jaws was examined. The reaction forces in the contact locating points were also computed and analyzed.

Application of Numerical Simulation for the Verification of Design of Clamping a Workpiece in Jaws

Institute of Applied Informatics, Automation and Mechatronics, Faculty of Materials Science and Technology in Trnava, Slovak University of Technology in Bratislava, Ulica Jána Bottu 2781/25, 917 24 Trnava, Slovak Republic

Research Papers Faculty of Materials Science and Technology Slovak University of Technology

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

This paper deals with the use of the numerical computer oriented method for the analysis and verification of the design of workpiece clamping. The inaccuracies...

Application of Numerical Simulation for the Verification of Design of Clamping a Workpiece in Jaws

Data publikacji: 04 kwi 2017

Zakres stron: 57 - 62

DOI: https://doi.org/10.1515/rput-2016-0017

Słowa kluczowe
contact locating points, FEM method, simulation, displacement, reaction force

© 2016 Jarmila Oravcová et al., published by De Gruyter Open

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Application of Numerical Simulation for the Verification of Design of Clamping a Workpiece in Jaws

Data publikacji: 04 kwi 2017

Zakres stron: 57 - 62

DOI: https://doi.org/10.1515/rput-2016-0017

Słowa kluczowecontact locating points, FEM method, simulation, displacement, reaction force

© 2016 Jarmila Oravcová et al., published by De Gruyter Open

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Słowa kluczowe
contact locating points, FEM method, simulation, displacement, reaction force