<abstract xmlns="http://www.w3.org/1999/xhtml">In this work, aluminate type phosphorescence materials were synthesized via the solid state reaction method and the photoluminescence (PL) properties, including excitation and emission bands, were investigated considering the effect of trace amounts of activator (Eu3+) and co-activator (Dy3+). The estimated thermal behavior of the samples at certain temperatures (> 1000 °C) during heat treatment was characterized by differential thermal analysis (DTA) and thermogravimetry (TG). The possible phase formation was characterized by X-ray diffraction (XRD). The morphological characterization of the samples was performed by scanning electron microscopy (SEM). The PL analysis of three samples showed maximum emission bands at around 610 nm, and additionally near 589 nm, 648 nm and 695 nm. The bands were attributed to typical transitions of the Eu3+ ions.</abstract>

In this work, aluminate type phosphorescence materials were synthesized via the solid state reaction method and the photoluminescence (PL) properties, including excitation and emission bands, were investigated considering the effect of trace amounts of activator (Eu3+) and co-activator (Dy3+). The estimated thermal behavior of the samples at certain temperatures (> 1000 °C) during heat treatment was characterized by differential thermal analysis (DTA) and thermogravimetry (TG). The possible phase formation was characterized by X-ray diffraction (XRD). The morphological characterization of the samples was performed by scanning electron microscopy (SEM). The PL analysis of three samples showed maximum emission bands at around 610 nm, and additionally near 589 nm, 648 nm and 695 nm. The bands were attributed to typical transitions of the Eu3+ ions.

Investigations of M3Al8O15:Eu3+,Dy3+ (M = Ba, Ca, Mg) phosphors

Karamanoğlu Mehmetbey University, Engineering Faculty, Department of Materials Science and Engineering, Karaman, Turkey

Materials Science-Poland

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Investigations of MAlO:Eu,Dy (M = Ba, Ca, Mg) phosphors

In this work, aluminate type phosphorescence materials were synthesized via the solid state reaction method and the photoluminescence (PL) properties,...

Investigations of M₃Al₈O₁₅:Eu³⁺,Dy³⁺ (M = Ba, Ca, Mg) phosphors

Article Category: Research Article

Data publikacji: 27 cze 2016

Zakres stron: 412 - 417

Otrzymano: 12 lis 2015

Przyjęty: 24 lut 2016

DOI: https://doi.org/10.1515/msp-2016-0047

Słowa kluczowe
aluminate phosphors, solid state reaction method, Eu, photoluminescence, phase formation

© Wroclaw University of Technology

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Investigations of M3Al8O15:Eu3+,Dy3+ (M = Ba, Ca, Mg) phosphors

Article Category: Research Article

Data publikacji: 27 cze 2016

Zakres stron: 412 - 417

Otrzymano: 12 lis 2015

Przyjęty: 24 lut 2016

DOI: https://doi.org/10.1515/msp-2016-0047

Słowa kluczowealuminate phosphors, solid state reaction method, Eu, photoluminescence, phase formation

© Wroclaw University of Technology

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Investigations of M₃Al₈O₁₅:Eu³⁺,Dy³⁺ (M = Ba, Ca, Mg) phosphors

Słowa kluczowe
aluminate phosphors, solid state reaction method, Eu, photoluminescence, phase formation