<abstract xmlns="http://www.w3.org/1999/xhtml">Luminescence dosimetry assumes samples of a given material with diverse provenances behave in a predictable manner, allowing a standardised testing protocol, such as SAR for quartz, to be employed. This article demonstrates that distinct salt products derived from a single manufacturer’s feedstock retain comparable luminescence behaviour. This is the basis of a standardised test protocol: uniting testing procedures which have been shown to be individually applicable. Generalization across samples from different manufacturers and processes is currently under investigation.Luminescent evaluation of five samples produced by Cheetham &amp; Co. gave useful intensities for all emission bands (590 nm, 420 nm and 360 nm TL and blue stimulated OSL), with the spectral and intensity balance of emissions generally similar for each sample. 590 nm emission sensitization was noted after preheating samples to 135°C and 300°C for five minutes. But, the 360 nm TL emission from feedstock salt was a factor of five greater than the same signal from the other processed samples despite the OSL intensity being similar to the other samples.Spectrum variation between aliquots as measured by the 3D TL spectrometer was also investigated and found to be minimal for both the first and second TL glow cycles.</abstract>

Luminescence dosimetry assumes samples of a given material with diverse provenances behave in a predictable manner, allowing a standardised testing protocol, such as SAR for quartz, to be employed. This article demonstrates that distinct salt products derived from a single manufacturer’s feedstock retain comparable luminescence behaviour. This is the basis of a standardised test protocol: uniting testing procedures which have been shown to be individually applicable. Generalization across samples from different manufacturers and processes is currently under investigation.Luminescent evaluation of five samples produced by Cheetham & Co. gave useful intensities for all emission bands (590 nm, 420 nm and 360 nm TL and blue stimulated OSL), with the spectral and intensity balance of emissions generally similar for each sample. 590 nm emission sensitization was noted after preheating samples to 135°C and 300°C for five minutes. But, the 360 nm TL emission from feedstock salt was a factor of five greater than the same signal from the other processed samples despite the OSL intensity being similar to the other samples.Spectrum variation between aliquots as measured by the 3D TL spectrometer was also investigated and found to be minimal for both the first and second TL glow cycles.

Investigation of the role of the production process on the luminescence of sea salt products

Geochronometria

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Luminescence dosimetry assumes samples of a given material with diverse provenances behave in a predictable manner, allowing a standardised testing protocol,...

Investigation of the role of the production process on the luminescence of sea salt products

Data publikacji: 01 cze 2017

Zakres stron: 121 - 128

Otrzymano: 16 maj 2016

Przyjęty: 19 sty 2017

DOI: https://doi.org/10.1515/geochr-2015-0055

Słowa kluczowe
TL, OSL, salt, retrospective dosimetry, NaCl

© 2016 P. G. Hunter and N. A. Spooner

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Investigation of the role of the production process on the luminescence of sea salt products

Data publikacji: 01 cze 2017

Zakres stron: 121 - 128

Otrzymano: 16 maj 2016

Przyjęty: 19 sty 2017

DOI: https://doi.org/10.1515/geochr-2015-0055

Słowa kluczoweTL, OSL, salt, retrospective dosimetry, NaCl

© 2016 P. G. Hunter and N. A. Spooner

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Słowa kluczowe
TL, OSL, salt, retrospective dosimetry, NaCl