<abstract xmlns="http://www.w3.org/1999/xhtml"><p>The article describes basic principles of induction bending and the change of mechanical properties from as received (straight) pipe made from HSLA steel to induction bend. The main purpose of this article is to experiment with tempering temperatures below 540°C. After tempering at 540°C which is the lowest recommended temperature for post bend heat treatment (PBHT) according to CSA specifications (Canadian Standards Association) the induction bend area in many cases does not achieve the minimum required mechanical properties and therefore it is not accepted for usage. In this article mechanical properties such as tensile, toughness, hardness are evaluated. Also the article contains microstructural analyses and comparison of bended and heat treated samples.</p></abstract>

The article describes basic principles of induction bending and the change of mechanical properties from as received (straight) pipe made from HSLA steel to induction bend. The main purpose of this article is to experiment with tempering temperatures below 540°C. After tempering at 540°C which is the lowest recommended temperature for post bend heat treatment (PBHT) according to CSA specifications (Canadian Standards Association) the induction bend area in many cases does not achieve the minimum required mechanical properties and therefore it is not accepted for usage. In this article mechanical properties such as tensile, toughness, hardness are evaluated. Also the article contains microstructural analyses and comparison of bended and heat treated samples.

Influence of Tempering on Mechanical Properties of Induction Bents below 540°C

Faculty of Mechanical Engineering, Department of Technological Engineering, University of Zilina, Univerzitna 8215/1, 010 26 Zilina, Slovakia

Faculty of Mechanical Engineering, Department of Designing and Machine Components, University of Zilina, Univerzitna 8215/1, 010 26 Zilina, Slovakia

Institute of Mechanics and Informatics, Chmelnitckiy National University, Str. Institutskaja 11, 29016 Chmelnitckiy, Ukraine

Acta Mechanica et Automatica

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

{"article-title":"Influence of Tempering on Mechanical Properties of Induction Bents below 540°C"}

The article describes basic principles of induction bending and the change of mechanical properties from as received (straight) pipe made from HSLA steel to...

Influence of Tempering on Mechanical Properties of Induction Bents below 540°C

Data publikacji: 08 cze 2016

Zakres stron: 81 - 86

Otrzymano: 22 paź 2015

Przyjęty: 10 mar 2016

DOI: https://doi.org/10.1515/ama-2016-0013

Słowa kluczowe
HSLA, Induction, Bending, Tempering

© 2016 Bialystok University of Technology

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Influence of Tempering on Mechanical Properties of Induction Bents below 540°C

Data publikacji: 08 cze 2016

Zakres stron: 81 - 86

Otrzymano: 22 paź 2015

Przyjęty: 10 mar 2016

DOI: https://doi.org/10.1515/ama-2016-0013

Słowa kluczoweHSLA, Induction, Bending, Tempering

© 2016 Bialystok University of Technology

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Słowa kluczowe
HSLA, Induction, Bending, Tempering