
15 Articoli
The study of the tribological properties under high contact pressure conditions of TiN, TiC and TiCN coatings deposited by the magnetron sputtering method on the AISI 304 stainless steel substrate
, , , , , , e
Comparison of Monte Carlo and bootstrap analyses for residual life and confidence interval
, , , , e
Structural, morphological, and optical properties of AgxO thin films deposited via obliquely angle deposition
, , e
Disk cutter wear prediction of TBM considering sliding and rolling friction
, , , , e
Influence of composition of curing agent and sand ratio of engineering excavated soil on mechanical properties of fluidized solidified soil
, e
Effect of ball milling on hexagonal boron nitride (hBN) and development of Al-hBN nanocomposites by powder metallurgy route
, , , , , e
Evaluation of the possibility of improving the durability of tools made of X153CrMoV12 steel used in the extrusion of a clay band in ceramic roof tile production
, , , e
Comparison of the performance properties of commercially produced roller cone bit coatings
, , , , , , e
Effect of heat treatment and cooling rate on microstructure and properties of T92 welded joint
, , e
Influence of elevated temperature on the engineering properties of ultra-high-performance fiber-reinforced concrete
, e
Comparative evaluation of mechanical properties of short aramid fiber on thermoplastic polymers
PLA filament is not equal to PLA filament: Experimental studies of the influence of the type of pigment on the mechanical and thermal properties of poly(lactic acid) products
, , e
Annealing effect on the structural and optoelectronic properties of Cu-Cr-O thin films deposited by reactive magnetron sputtering using a single CuCr target
, , , e
Regulation of N-type In2O3 Content on the Conductivity Type of Co3O4 Based Acetone Sensor
, , e
Application of machine vision for the detection of powder bed defects in additive manufacturing processes
, e