<abstract xmlns="http://www.w3.org/1999/xhtml"><p>Industrial Computed Tomography (CT) is a broadly used measurement method allowing for quality control of objects produced using additive manufacturing methods. The combination of tensile tests and simultaneous 3D imaging of the behavior of an object under a particular force (i.e. in situ examination – during the process) significantly broadens the possibilities of analyzing objects with a complex internal geometry. The purpose of this paper is to present the author’s project of a mini testing machine, to verify its functioning with regards to a static testing machine, and to present the initial in situ examination results for polymer samples.</p></abstract>

Industrial Computed Tomography (CT) is a broadly used measurement method allowing for quality control of objects produced using additive manufacturing methods. The combination of tensile tests and simultaneous 3D imaging of the behavior of an object under a particular force (i.e. in situ examination – during the process) significantly broadens the possibilities of analyzing objects with a complex internal geometry. The purpose of this paper is to present the author’s project of a mini testing machine, to verify its functioning with regards to a static testing machine, and to present the initial in situ examination results for polymer samples.

New possibilities for <italic>in situ</italic> CT analysis of additive manufactured samples

Faculty of Mechanical Engineering, Centre for Advanced Manufacturing Technologies (CAMT/FPC)

Wroclaw University of Science and Technology

Technical Transactions

This work is licensed under the Creative Commons Attribution-ShareAlike 4.0 International License.

New possibilities for  CT analysis of additive manufactured samples

Industrial Computed Tomography (CT) is a broadly used measurement method allowing for quality control of objects produced using additive manufacturing methods....

New possibilities for in situ CT analysis of additive manufactured samples

Publié en ligne: 19 sept. 2020

Pages: -

Reçu: 16 oct. 2019

Accepté: 09 sept. 2020

DOI: https://doi.org/10.37705/TechTrans/e2020028

Mots clés
industrial computed tomography, mechanical properties, polymers, additive manufacturing

© 2020 Grzegorz Ziółkowski et al., published by Sciendo

This work is licensed under the Creative Commons Attribution-ShareAlike 4.0 International License.

New possibilities for in situ CT analysis of additive manufactured samples

Publié en ligne: 19 sept. 2020

Pages: -

Reçu: 16 oct. 2019

Accepté: 09 sept. 2020

DOI: https://doi.org/10.37705/TechTrans/e2020028

Mots clésindustrial computed tomography, mechanical properties, polymers, additive manufacturing

© 2020 Grzegorz Ziółkowski et al., published by Sciendo

This work is licensed under the Creative Commons Attribution-ShareAlike 4.0 International License.

Mots clés
industrial computed tomography, mechanical properties, polymers, additive manufacturing