Study on the absorption technology of distribution network with high-proportion distributed power supply

In order to reduce energy dissipation and alleviate the energy crisis, this paper proposes an absorption mode of distribution network with distributed power supply. First of all, the starting power coefficient and cutting off power coefficient are set to reflect the efficiency of the inverter and obtain the active output power of the photovoltaic system. Then, the Gaussian iterative algorithm is used to calculate the power flow of the distribution network, which forms a model along with the branch switch to complete the variables optimization under the conditions that all power conversion elements are removed from the system and the security constraint is satisfied. Afterwards, through the apparent power of the distribution network node, the single feeder is transformed into two feeders to ensure the fixed voltage at the front end of the line and make the node voltage rise and exceed the limit. Meanwhile, the active power and reactive power are provided for distribution network to reduce the feeders voltage loss, the reasonable regulation measures are used to stabilize the voltage, and the constant power factor and voltage amplitude of the network connection point are added to address voltage over limit and lighten the influence of increasing distributed power on voltage rising. Finally, the size of voltage amplitude is referred to determine the reactive power, so as to realize reasonable absorption of distribution network. The analysis results show that the voltage regulation measures proposed significantly improve the overall absorption capacity of the power supply, with the capacity increased by 0.54MW and 0.2MW respectively.