<abstract xmlns="http://www.w3.org/1999/xhtml">As a crucial core physics parameter, the control rod reactivity has to be predicted for the control and safety of the reactor. This paper studies the control rod reactivity calculation of the pebble-bed reactor with three scenarios of UO2, (Th,U)O2, and PuO2 fuel type without any modifications in the configuration of the reactor core. The reactor geometry of HTR-10 was selected for the reactor model. The entire calculation of control rod reactivity was done using the MCNP6 code with ENDF/B-VII library. The calculation results show that the total reactivity worth of control rods in UO2-, (U,Th)O2-, and PuO2-fueled cores is 15.87, 15.25, and 14.33%Δ<italic>k</italic>/<italic>k</italic>, respectively. These results prove that the effectiveness of total control rod in thorium and uranium cores is almost similar to but higher than that in plutonium cores. The highest reactivity worth of individual control rod in uranium, thorium and plutonium cores is 1.64, 1.44, and 1.53%Δ<italic>k</italic>/<italic>k</italic> corresponding to CR8, CR1, and CR5, respectively. The other results demonstrate that the reactor can be safely shutdown with the control rods combination of CR3+CR5+CR8+CR10, CR2+CR3+CR7+CR8, and CR1+CR3+CR6+CR8 in UO2-, (U,Th)O2-, and PuO2-fueled cores, respectively. It can be concluded that, even though the calculation results are not so much different, however, the selection of control rods should be considered in the pebble-bed core design with different scenarios of fuel type.</abstract>

As a crucial core physics parameter, the control rod reactivity has to be predicted for the control and safety of the reactor. This paper studies the control rod reactivity calculation of the pebble-bed reactor with three scenarios of UO2, (Th,U)O2, and PuO2 fuel type without any modifications in the configuration of the reactor core. The reactor geometry of HTR-10 was selected for the reactor model. The entire calculation of control rod reactivity was done using the MCNP6 code with ENDF/B-VII library. The calculation results show that the total reactivity worth of control rods in UO2-, (U,Th)O2-, and PuO2-fueled cores is 15.87, 15.25, and 14.33%Δk/k, respectively. These results prove that the effectiveness of total control rod in thorium and uranium cores is almost similar to but higher than that in plutonium cores. The highest reactivity worth of individual control rod in uranium, thorium and plutonium cores is 1.64, 1.44, and 1.53%Δk/k corresponding to CR8, CR1, and CR5, respectively. The other results demonstrate that the reactor can be safely shutdown with the control rods combination of CR3+CR5+CR8+CR10, CR2+CR3+CR7+CR8, and CR1+CR3+CR6+CR8 in UO2-, (U,Th)O2-, and PuO2-fueled cores, respectively. It can be concluded that, even though the calculation results are not so much different, however, the selection of control rods should be considered in the pebble-bed core design with different scenarios of fuel type.

The effects of fuel type on control rod reactivity of pebble-bed reactor

Center for Nuclear Reactor Technology and Safety, National Nuclear Energy Agency of Indonesia

Nukleonika

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 License.

{"article-title":"The effects of fuel type on control rod reactivity of pebble-bed reactor"}

As a crucial core physics parameter, the control rod reactivity has to be predicted for the control and safety of the reactor. This paper studies the control...

The effects of fuel type on control rod reactivity of pebble-bed reactor

Online veröffentlicht: 11. Dez. 2019

Seitenbereich: 131 - 138

Eingereicht: 23. Apr. 2019

Akzeptiert: 04. Sept. 2019

DOI: https://doi.org/10.2478/nuka-2019-0017

Schlüsselwörter
fuel type, control rod reactivity, pebble-bed reactor, MCNP6, ENDF/B-VII

© 2019 Zuhair et al., published by Sciendo

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 License.

The effects of fuel type on control rod reactivity of pebble-bed reactor

Online veröffentlicht: 11. Dez. 2019

Seitenbereich: 131 - 138

Eingereicht: 23. Apr. 2019

Akzeptiert: 04. Sept. 2019

DOI: https://doi.org/10.2478/nuka-2019-0017

Schlüsselwörterfuel type, control rod reactivity, pebble-bed reactor, MCNP6, ENDF/B-VII

© 2019 Zuhair et al., published by Sciendo

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 License.

Schlüsselwörter
fuel type, control rod reactivity, pebble-bed reactor, MCNP6, ENDF/B-VII