<abstract xmlns="http://www.w3.org/1999/xhtml"><p>In this article, the attention is paid to the HVOF (High Velocity Oxygen Fuel) thermal spraying method by which the progressive coatings are applied on basic material C15E (STN 412020). These coatings are based on C-17CO, WC-CO-Cr and Cr3C2-25NiCr. There was made determination of the chemical composition of the coatings and assessment of coatings quality - adhesion, microhardness, porosity and wear resistance at room temperature (21°C) and also at operational elevated temperature (900°C). Results of adhesive wear showed high quality of all evaluated coatings and their suitability to extreme tribological conditions.</p></abstract>

In this article, the attention is paid to the HVOF (High Velocity Oxygen Fuel) thermal spraying method by which the progressive coatings are applied on basic material C15E (STN 412020). These coatings are based on C-17CO, WC-CO-Cr and Cr3C2-25NiCr. There was made determination of the chemical composition of the coatings and assessment of coatings quality - adhesion, microhardness, porosity and wear resistance at room temperature (21°C) and also at operational elevated temperature (900°C). Results of adhesive wear showed high quality of all evaluated coatings and their suitability to extreme tribological conditions.

ASSESSMENT TRIBOLOGICAL PROPERTIES OF COATINGS APPLIED BY HVOF TECHNOLOGY

Faculty of Mechanical Engineering, Department of Technology and Materials, Technical University of Košice, Mäsiarska 74, 040 01 Košice, Slovakia

SLOVNAFT Montáže a Opravy, a.s., Vlčie hrdlo, P.O.Box 52, 820 03 Bratislava, Slovakia

Acta Mechanica et Automatica

{"article-title":"ASSESSMENT TRIBOLOGICAL PROPERTIES OF COATINGS APPLIED BY HVOF TECHNOLOGY"}

In this article, the attention is paid to the HVOF (High Velocity Oxygen Fuel) thermal spraying method by which the progressive coatings are applied on basic...

ASSESSMENT TRIBOLOGICAL PROPERTIES OF COATINGS APPLIED BY HVOF TECHNOLOGY

Online veröffentlicht: 22. Jan. 2014

Seitenbereich: 135 - 139

DOI: https://doi.org/10.2478/ama-2013-0023

This content is open access.