<abstract xmlns="http://www.w3.org/1999/xhtml"><p>The paper is focused on reducing machining time by using 3D optical scanner of ATOS Triplescan II. Workpiece was a forging die, which was renovated by hard facing. The contribution deals with comparing the CAM simulation of roughing process according to the STL model imported from ATOS, and simulation without thus-defined workpiece. The results indicate a significant improvement of machining time based on CAQ technology and usage of the ATOS device for measuring the errors of weld deposit.</p></abstract>

The paper is focused on reducing machining time by using 3D optical scanner of ATOS Triplescan II. Workpiece was a forging die, which was renovated by hard facing. The contribution deals with comparing the CAM simulation of roughing process according to the STL model imported from ATOS, and simulation without thus-defined workpiece. The results indicate a significant improvement of machining time based on CAQ technology and usage of the ATOS device for measuring the errors of weld deposit.

Reduction of Milling Time by Using CAQ Technologies

Institute of Production Technologies, Faculty of Materials Science and Technology in Trnava, Slovak University of Technology in Bratislava, Ulica Jána Bottu 2781/25, 917 24 Trnava, Slovak Republic

Research Papers Faculty of Materials Science and Technology Slovak University of Technology

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

{"article-title":"Reduction of Milling Time by Using CAQ Technologies"}

The paper is focused on reducing machining time by using 3D optical scanner of ATOS Triplescan II. Workpiece was a forging die, which was renovated by hard...

Reduction of Milling Time by Using CAQ Technologies

Online veröffentlicht: 04. Apr. 2017

Seitenbereich: 81 - 86

DOI: https://doi.org/10.1515/rput-2016-0042

Schlüsselwörter
simulation, scan, machining, CAM, weld, deposit, deviation

© 2016 Rudolf Zaujec et al., published by De Gruyter Open

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Reduction of Milling Time by Using CAQ Technologies

Online veröffentlicht: 04. Apr. 2017

Seitenbereich: 81 - 86

DOI: https://doi.org/10.1515/rput-2016-0042

Schlüsselwörtersimulation, scan, machining, CAM, weld, deposit, deviation

© 2016 Rudolf Zaujec et al., published by De Gruyter Open

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Schlüsselwörter
simulation, scan, machining, CAM, weld, deposit, deviation