The influence of the soil constitutive models on the seismic analysis of pile-supported wharf structures with batter piles in cut-slope rock dike
, and
Jul 05, 2020
About this article
Article Category: Original Study
Published Online: Jul 05, 2020
Page range: 191 - 209
Received: Jun 21, 2019
Accepted: May 07, 2020
DOI: https://doi.org/10.2478/sgem-2019-0050
Keywords
© 2020 Lylia Deghoul et al., published by Sciendo
This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.
Figure 1

Figure 2
![Stiffness parameters of standard drained triaxial test results: (1) for the MC model, (2) for the HS model, (3) for the HSS model [66]](https://sciendo-parsed.s3.eu-central-1.amazonaws.com/647378c74e662f30ba53f7fe/j_sgem-2019-0050_fig_002.jpg?X-Amz-Algorithm=AWS4-HMAC-SHA256&X-Amz-Content-Sha256=UNSIGNED-PAYLOAD&X-Amz-Credential=AKIA6AP2G7AKOUXAVR44%2F20250919%2Feu-central-1%2Fs3%2Faws4_request&X-Amz-Date=20250919T173855Z&X-Amz-Expires=3600&X-Amz-Signature=9364b08c079f5b57f3b52ff15b7dbc815e1a9792bde569e298568c0b5b3126f0&X-Amz-SignedHeaders=host&x-amz-checksum-mode=ENABLED&x-id=GetObject)
Figure 3
![Characteristic stiffness-strain behavior in logarithmic scale (after Atkinson and Sallfors [36] and Mair[76]) (Atkinson, 2000)[77].](https://sciendo-parsed.s3.eu-central-1.amazonaws.com/647378c74e662f30ba53f7fe/j_sgem-2019-0050_fig_003.jpg?X-Amz-Algorithm=AWS4-HMAC-SHA256&X-Amz-Content-Sha256=UNSIGNED-PAYLOAD&X-Amz-Credential=AKIA6AP2G7AKOUXAVR44%2F20250919%2Feu-central-1%2Fs3%2Faws4_request&X-Amz-Date=20250919T173855Z&X-Amz-Expires=3600&X-Amz-Signature=d4b8ba1d62e9f7062ab4b6113030489d4baf72a2cbf38da429ed9a3977463790&X-Amz-SignedHeaders=host&x-amz-checksum-mode=ENABLED&x-id=GetObject)
Figure 4

Figure 5

Figure 6

Figure 7

Figure 8

Figure 9
![Nodal displacement vectors for the wharf supported piles (m)[28].](https://sciendo-parsed.s3.eu-central-1.amazonaws.com/647378c74e662f30ba53f7fe/j_sgem-2019-0050_fig_009.jpg?X-Amz-Algorithm=AWS4-HMAC-SHA256&X-Amz-Content-Sha256=UNSIGNED-PAYLOAD&X-Amz-Credential=AKIA6AP2G7AKOUXAVR44%2F20250919%2Feu-central-1%2Fs3%2Faws4_request&X-Amz-Date=20250919T173855Z&X-Amz-Expires=3600&X-Amz-Signature=b46954fd9d95a1a5354386fd1d68a49e3ceea2f546274c7f486a641583c477c2&X-Amz-SignedHeaders=host&x-amz-checksum-mode=ENABLED&x-id=GetObject)
Figure 10

Figure 11
![Total pore pressure contours (Pa)[28].](https://sciendo-parsed.s3.eu-central-1.amazonaws.com/647378c74e662f30ba53f7fe/j_sgem-2019-0050_fig_011.jpg?X-Amz-Algorithm=AWS4-HMAC-SHA256&X-Amz-Content-Sha256=UNSIGNED-PAYLOAD&X-Amz-Credential=AKIA6AP2G7AKOUXAVR44%2F20250919%2Feu-central-1%2Fs3%2Faws4_request&X-Amz-Date=20250919T173855Z&X-Amz-Expires=3600&X-Amz-Signature=9f2e9611936399887c6818cb2ad47afddd7399f4c4a7662bf8b54fce11984301&X-Amz-SignedHeaders=host&x-amz-checksum-mode=ENABLED&x-id=GetObject)
Figure 12

Soil parameters used for HS model
kN/m2 | 6.032 × 104 | 1.638 × 104 | 2.232 × 104 | |
kN/m2 | 4.826 × 104 | 1.310 × 104 | 1.786 × 104 | |
kN/m2 | 1.810 × 104 | 4.914 × 104 | 6.696 × 104 | |
kN/m2 | 100 | 100 | 100 | |
- | 0.5 | 0.5 | 0.5 | |
- | 0.3982 | 0.4524 | 0.2929 | |
- | 0.9 | 0.9 | 0.9 |
Additional input parameters of HSS model_
4.918 × 10–4 | 3.629 × 10–4 | 4.246 × 10–4 | ||
kN/m2 | 1.051 × 105 | 9.108 × 104 | 1.038 × 105 |
Lateral and vertical displacement time histories at the top and at the toe of the rock dike_
Soil parameters used for the MC model_
° | 37 | 33.2 | 45 | |
° | 21 | 7 | 0 | |
kN/m2 | 0.5 | 0.5 | 15 | |
- | 0.3 | 0.3 | 0.2 | |
kN/m2 | 6.032 × 104 | 1.638 × 104 | 2.232 × 104 |
Pile and deck properties_
kN/m | 162.75 × 104 | 17.85 × 106 | |
kN.m2/m | 70.49 × 103 | 96.724 × 103 | |
kN/m/m | 0.633 | 6.9436 | |
- | 0.2 | 0.2 |