Erratum to “Fabrication and characterization of a 3D printing filament from polylactic acid and Cryptostegia grandiflora fibers”
, , , , , , and
Dec 31, 2024
About this article
Article Category: Erratum
Published Online: Dec 31, 2024
Page range: 162 - 162
Received: Jan 04, 2025
Accepted: Jan 21, 2025
DOI: https://doi.org/10.2478/msp-2024-0739
Keywords
© 2024 the A. Udhayakumar et al., published by Sciendo
This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.
Udhayakumar, A.
Department of Mechanical Engineering, School of Mech, Auto, Aero and Civil Engineering, Kalasalingam Academy of Research and EducationVirudhunagar Dt., India
Mayandi, K.
Department of Mechanical Engineering, School of Mech, Auto, Aero and Civil Engineering, Kalasalingam Academy of Research and EducationVirudhunagar Dt., India
Rajini, N.
Department of Mechanical Engineering, School of Mech, Auto, Aero and Civil Engineering, Kalasalingam Academy of Research and EducationVirudhunagar Dt., India
Murali, M.
Department of Mechanical Engineering, School of Mech, Auto, Aero and Civil Engineering, Kalasalingam Academy of Research and EducationVirudhunagar Dt., India
Mohammad, Faruq
Department of Chemistry, College of Science, King Saud UniversityRiyadh, Saudi Arabia
Al-Lohedan, Hamad A.
Department of Chemistry, College of Science, King Saud UniversityRiyadh, Saudi Arabia
Krishnan, Kumar
Faculty of Health and Life Sciences, INTI International University, Persiaran Perdana BBNNilai, Malaysia
Santulli, Carlo
School of Science and Technology, Geology Section, University of CamerinoCamerino, Italy