<abstract xmlns="http://www.w3.org/1999/xhtml">

<p>A method of compensation is proposed based on the error model with the robot’s parameters of kinematic structure and the joint angle. Using the robot kinematics equation depending on D-H algorithm, a kinematic error model is deduced relative to the end actuator of the robot, a comprehensive compensation method of kinematic parameters’ error by mapping structural parameters to the joint angular parameter is proposed. In order to solve the angular error problem in the compensation process of each joint, designs a set of robot’s kinematic parameter compensation experiment based on the joint angle’s correction. The experimental results verify the effectiveness of the presented method. Besides, puts forward that the main factor of the dynamic error is the deformation of the connecting rods. Software compensation way is analyzed in the paper.</p></abstract>

A method of compensation is proposed based on the error model with the robot’s parameters of kinematic structure and the joint angle. Using the robot kinematics equation depending on D-H algorithm, a kinematic error model is deduced relative to the end actuator of the robot, a comprehensive compensation method of kinematic parameters’ error by mapping structural parameters to the joint angular parameter is proposed. In order to solve the angular error problem in the compensation process of each joint, designs a set of robot’s kinematic parameter compensation experiment based on the joint angle’s correction. The experimental results verify the effectiveness of the presented method. Besides, puts forward that the main factor of the dynamic error is the deformation of the connecting rods. Software compensation way is analyzed in the paper.

Error Analysis and Compensation Method of 6-axis Industrial Robot

International Journal on Smart Sensing and Intelligent Systems

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.

{"article-title":"Error Analysis and Compensation Method of 6-axis Industrial Robot"}

A method of compensation is proposed based on the error model with the robot’s parameters of kinematic structure and the joint angle. Using the robot...

Error Analysis and Compensation Method of 6-axis Industrial Robot

Published Online: Sep 05, 2013

Page range: 1383 - 1399

DOI: https://doi.org/10.21307/ijssis-2017-595

© 2013 Jianhao Zhang et al., published by Sciendo

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.