<abstract xml:lang="en" xmlns="http://www.w3.org/1999/xhtml"><p> The paper deals with the measurement and identification of surfaces after machining in a non-contact manner. It presents a new modified measurement method and its implementation, the results of intensity distribution in the defocusing plane, their analysis and interpretation. The scanned intensity distribution at the defocusing plane gives information necessary to assess the second derivatives, and thus, surface functions which can be used to determine groove curvatures of the real surface morphology. The proposed method of measurement has proved to be very sensitive in evaluating the differences between surface finishing methods by which the measured surface standards (etalons) were machined. Two methods of machining were chosen: face grinding and planning. By comparing the roughness standard values <italic>Ra</italic>, there were obtained relationships between these values and the parameter of the characteristic frequency of vertical inequality being measured according to the presented method. A good correlation between the measured and surface standard values with the correlation coefficient taking a range of values from 0.8 to 1 was achieved.</p></abstract>

The paper deals with the measurement and identification of surfaces after machining in a non-contact manner. It presents a new modified measurement method and its implementation, the results of intensity distribution in the defocusing plane, their analysis and interpretation. The scanned intensity distribution at the defocusing plane gives information necessary to assess the second derivatives, and thus, surface functions which can be used to determine groove curvatures of the real surface morphology. The proposed method of measurement has proved to be very sensitive in evaluating the differences between surface finishing methods by which the measured surface standards (etalons) were machined. Two methods of machining were chosen: face grinding and planning. By comparing the roughness standard values Ra, there were obtained relationships between these values and the parameter of the characteristic frequency of vertical inequality being measured according to the presented method. A good correlation between the measured and surface standard values with the correlation coefficient taking a range of values from 0.8 to 1 was achieved.

Non-contact method for surface roughness measurement after machining

Institute of Physics, Faculty of Mining and Geology, VŠB - Technical University of Ostrava, 17. listopadu 15/2172, 708 33 Ostrava-Poruba, Czech Republic

Institute of Construction and Architecture, Slovak Academy of Sciences, Dúbravská cesta 9, 845 03 Bratislava, Slovakia

Division of Surface Electrochemistry and Technology, Koszalin University of Technology, Racławicka 15-17, PL 75-620 Koszalin, Poland

Nanotechnology Centre, VŠB - Technical University of Ostrava, 17. listopadu 15/2172, 708 33 Ostrava-Poruba, Czech Republic

Department of Informatics and Computers, Faculty of Science, University of Ostrava, 30. dubna 22, 701 03 Ostrava, Czech Republic

Measurement Science Review

{"article-title":"Non-contact method for surface roughness measurement after machining"}

The paper deals with the measurement and identification of surfaces after machining in a non-contact manner. It presents a new modified measurement method and...

Non-contact method for surface roughness measurement after machining

Pubblicato online: 21 ott 2012

Pagine: 184 - 188

DOI: https://doi.org/10.2478/v10048-012-0028-3

This content is open access.