<abstract xmlns="http://www.w3.org/1999/xhtml">

<p>The results of the computer simulation of the cutting process of gears by the power skiving method are presented. Following the kinematics of the process, a method for generating 3D geometric models of undeformed sheared layers were developed, and their parameters were analyzed. The influence of tool geometry and technological parameters on cutting conditions is investigated. The simulation results and calculation of the tangential force and torque on the tool axis and their influence on the error due to angular elastic deformation of the tool are given.</p>
</abstract>

The results of the computer simulation of the cutting process of gears by the power skiving method are presented. Following the kinematics of the process, a method for generating 3D geometric models of undeformed sheared layers were developed, and their parameters were analyzed. The influence of tool geometry and technological parameters on cutting conditions is investigated. The simulation results and calculation of the tangential force and torque on the tool axis and their influence on the error due to angular elastic deformation of the tool are given.

Simulation of a Power Skiving Gear Cutting Process

Strojnícky časopis - Journal of Mechanical Engineering

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

{"article-title":"Simulation of a Power Skiving Gear Cutting Process"}

The results of the computer simulation of the cutting process of gears by the power skiving method are presented. Following the kinematics of the process, a...

Simulation of a Power Skiving Gear Cutting Process

Pubblicato online: 25 mag 2023

Pagine: 103 - 116

DOI: https://doi.org/10.2478/scjme-2023-0008

© 2023 Hrytsay Ihor et al., published by Sciendo

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.