<abstract xmlns="http://www.w3.org/1999/xhtml">

<p>A mathematical module for predicting and analysing the drawing forces is formed and verified. The process used in the current study is drawing. Geometric parameters of the deformation zone and the “selective transfer phenomenon” are also taken into consideration. The experimental verification is conducted through two tests: In the first test, the experimental blanks are cylindrical rods (steel 45, length 150 mm), and are preliminary turned, and the drawplate made of steel 9xc, are used. Regular micro-relief (RMR) hardens the working surfaces of the drawplate. In the second test, the same conditions are applied except for the samples, which represent solid cylindrical billets made of steel 45 with a complicatedly modified surface layer, including a brass film, regular microgeometry and a “servo-witte” copper film. As a result, in the first experiment, the discrepancies are in the range of -29.1% up to +23%. In the second experiment, the discrepancies are in the range of +1.38% up to +48.9%.</p>
</abstract>

A mathematical module for predicting and analysing the drawing forces is formed and verified. The process used in the current study is drawing. Geometric parameters of the deformation zone and the “selective transfer phenomenon” are also taken into consideration. The experimental verification is conducted through two tests: In the first test, the experimental blanks are cylindrical rods (steel 45, length 150 mm), and are preliminary turned, and the drawplate made of steel 9xc, are used. Regular micro-relief (RMR) hardens the working surfaces of the drawplate. In the second test, the same conditions are applied except for the samples, which represent solid cylindrical billets made of steel 45 with a complicatedly modified surface layer, including a brass film, regular microgeometry and a “servo-witte” copper film. As a result, in the first experiment, the discrepancies are in the range of -29.1% up to +23%. In the second experiment, the discrepancies are in the range of +1.38% up to +48.9%.

Predicting the Burnishing Force for Cylindrical Workpieces with Amodified Surface Layer

Strojnícky časopis - Journal of Mechanical Engineering

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

A mathematical module for predicting and analysing the drawing forces is formed and verified. The process used in the current study is drawing. Geometric...

Predicting the Burnishing Force for Cylindrical Workpieces with Amodified Surface Layer

Pubblicato online: 09 mag 2022

Pagine: 35 - 48

DOI: https://doi.org/10.2478/scjme-2022-0004

Parole chiave
drawing force, regular micro-relief, deformation zone, metal-cladding lubricants

© 2022 Fanidi Omar et al., published by Sciendo

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Predicting the Burnishing Force for Cylindrical Workpieces with Amodified Surface Layer

Pubblicato online: 09 mag 2022

Pagine: 35 - 48

DOI: https://doi.org/10.2478/scjme-2022-0004

Parole chiavedrawing force, regular micro-relief, deformation zone, metal-cladding lubricants

© 2022 Fanidi Omar et al., published by Sciendo

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Parole chiave
drawing force, regular micro-relief, deformation zone, metal-cladding lubricants