<abstract xmlns="http://www.w3.org/1999/xhtml">

<p>Today, the world is facing an enormous challenge where the emissions of greenhouse gases must be reduced significantly to stop the increasing mean temperature. For the construction industry, this challenge means that structures must be designed more carefully, and materials must be used and produced more efficiently. Concrete is one of the most widely used materials, and cement production alone contributes to around 8 % of the world’s total CO<sub>2</sub> emissions. This paper presents a pilot study in which part of the cement clinker content in accelerated shotcrete is replaced with ground granulated blast furnace slag (GGBS). Shotcrete is widely used as part of the rock support for tunnels in hard rock and has a large cement content. Thus, the environmental impact must be reduced significantly to meet future demands. However, introducing GGBS will slow down strength development, which is a crucial part of shotcrete. Thus, this paper aims to investigate the early strength development, i.e., after one and seven days. The results show that an average compressive strength of 18 MPa can be reached after 24 hours when 35 % of the cement clinker content is replaced with GGBS. Finally, some important topics for further studies are pointed out.</p>
</abstract>

Today, the world is facing an enormous challenge where the emissions of greenhouse gases must be reduced significantly to stop the increasing mean temperature. For the construction industry, this challenge means that structures must be designed more carefully, and materials must be used and produced more efficiently. Concrete is one of the most widely used materials, and cement production alone contributes to around 8 % of the world’s total CO2 emissions. This paper presents a pilot study in which part of the cement clinker content in accelerated shotcrete is replaced with ground granulated blast furnace slag (GGBS). Shotcrete is widely used as part of the rock support for tunnels in hard rock and has a large cement content. Thus, the environmental impact must be reduced significantly to meet future demands. However, introducing GGBS will slow down strength development, which is a crucial part of shotcrete. Thus, this paper aims to investigate the early strength development, i.e., after one and seven days. The results show that an average compressive strength of 18 MPa can be reached after 24 hours when 35 % of the cement clinker content is replaced with GGBS. Finally, some important topics for further studies are pointed out.

The Use of Slag in Accelerated Shotcrete for Rock Support: A Pilot Study on the Influence on the Early Compressive Strength

MSc, Researcher Assistant, Eastern Switzerland University of Applied Sciences

Nordic Concrete Research

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Today, the world is facing an enormous challenge where the emissions of greenhouse gases must be reduced significantly to stop the increasing mean temperature....

The Use of Slag in Accelerated Shotcrete for Rock Support: A Pilot Study on the Influence on the Early Compressive Strength

Pubblicato online: 06 gen 2024

Pagine: 73 - 86

Ricevuto: 17 ott 2023

Accettato: 05 dic 2023

DOI: https://doi.org/10.2478/ncr-2023-0012

Parole chiave
shotcrete, blast furnace slag, compressive strength, laboratory test, rock support

© 2023 Elin Brodd et al., published by Sciendo

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

The Use of Slag in Accelerated Shotcrete for Rock Support: A Pilot Study on the Influence on the Early Compressive Strength

Pubblicato online: 06 gen 2024

Pagine: 73 - 86

Ricevuto: 17 ott 2023

Accettato: 05 dic 2023

DOI: https://doi.org/10.2478/ncr-2023-0012

Parole chiaveshotcrete, blast furnace slag, compressive strength, laboratory test, rock support

© 2023 Elin Brodd et al., published by Sciendo

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Parole chiave
shotcrete, blast furnace slag, compressive strength, laboratory test, rock support