<abstract xmlns="http://www.w3.org/1999/xhtml"><p>Co–Zn nanocrystalline ferrites with chemical composition Co0:5Zn0:5Fe2O4 were synthesized by sol-gel and combustion methods. The sol-gel method was carried out in two ways, i.e. based on chelating agents PVA and PEG of high and low molecular weights. In auto-combustion method, the ratio of citric acid to metal nitrate was taken as 1:1, while in sol-gel method the chelating agents were taken based on oxygen balance. All the three samples were studied by thermogravimetric and differential thermal analysis for the identification of phase formation and ferritization temperature. The synthesized samples were characterized by powder X-ray diffraction and FT-IR spectroscopy without any thermal treatment. The measured lattice constants and observed characteristic IR absorption bands of the three samples are in good agreement with the reported values showing the formation of a cubic spinel structure. The crystallite sizes of all samples were determined using high intensity peaks and W-H plot. Size-Strain Plot method was also implemented since two of the samples showed low crystallite sizes. The least crystallite size (5.5 nm) was observed for the sample CZVP while the highest (23.8 nm) was observed for the sample CZCA. Cation distribution was proposed based on calculated and observed intensity ratios of selected planes from X ray diffraction data. All structural parameters were presented using experimental lattice constant and oxygen positional parameter, and they correlated with FT-IR results. Magnetic measurements were carried out using vibrating sample magnetometer at room temperature to obtain the characteristic parameters such as saturation magnetization, coercivity, remanence, squareness ratio and Bohr magnetons. Among all, the sample synthesized via citric acid autocombustion method displayed a remarkably higher magnetization of 53 emu/g and the remaining two samples displayed low magnetization values owing to their smaller crystallite sizes.</p></abstract>

Co–Zn nanocrystalline ferrites with chemical composition Co0:5Zn0:5Fe2O4 were synthesized by sol-gel and combustion methods. The sol-gel method was carried out in two ways, i.e. based on chelating agents PVA and PEG of high and low molecular weights. In auto-combustion method, the ratio of citric acid to metal nitrate was taken as 1:1, while in sol-gel method the chelating agents were taken based on oxygen balance. All the three samples were studied by thermogravimetric and differential thermal analysis for the identification of phase formation and ferritization temperature. The synthesized samples were characterized by powder X-ray diffraction and FT-IR spectroscopy without any thermal treatment. The measured lattice constants and observed characteristic IR absorption bands of the three samples are in good agreement with the reported values showing the formation of a cubic spinel structure. The crystallite sizes of all samples were determined using high intensity peaks and W-H plot. Size-Strain Plot method was also implemented since two of the samples showed low crystallite sizes. The least crystallite size (5.5 nm) was observed for the sample CZVP while the highest (23.8 nm) was observed for the sample CZCA. Cation distribution was proposed based on calculated and observed intensity ratios of selected planes from X ray diffraction data. All structural parameters were presented using experimental lattice constant and oxygen positional parameter, and they correlated with FT-IR results. Magnetic measurements were carried out using vibrating sample magnetometer at room temperature to obtain the characteristic parameters such as saturation magnetization, coercivity, remanence, squareness ratio and Bohr magnetons. Among all, the sample synthesized via citric acid autocombustion method displayed a remarkably higher magnetization of 53 emu/g and the remaining two samples displayed low magnetization values owing to their smaller crystallite sizes.

Structural and magnetic studies on Co-Zn nanoferrite synthesized via sol-gel and combustion methods

Department of Electronics & Physics, GITAM Institute of Science

Defence Metallurgical Research Laboratory

Materials Science-Poland

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 License.

Co–Zn nanocrystalline ferrites with chemical composition Co0:5Zn0:5Fe2O4 were synthesized by sol-gel and combustion methods. The sol-gel method was carried out...

Structural and magnetic studies on Co-Zn nanoferrite synthesized via sol-gel and combustion methods

Pubblicato online: 06 mar 2019

Pagine: 39 - 54

Ricevuto: 26 mag 2017

Accettato: 17 mag 2018

DOI: https://doi.org/10.2478/msp-2019-0013

Parole chiave
nanoferrite, cation distribution, FT-IR spectroscopy, magnetization

© 2019 B.B.V.S. Vara Prasad et al., published by Sciendo

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 License.

Structural and magnetic studies on Co-Zn nanoferrite synthesized via sol-gel and combustion methods

Pubblicato online: 06 mar 2019

Pagine: 39 - 54

Ricevuto: 26 mag 2017

Accettato: 17 mag 2018

DOI: https://doi.org/10.2478/msp-2019-0013

Parole chiavenanoferrite, cation distribution, FT-IR spectroscopy, magnetization

© 2019 B.B.V.S. Vara Prasad et al., published by Sciendo

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 License.

Parole chiave
nanoferrite, cation distribution, FT-IR spectroscopy, magnetization