<abstract xmlns="http://www.w3.org/1999/xhtml"><p>In this paper, four differently shaped Wilkinson power dividers are presented by selecting the same physical length of two-section transmission lines, dual arbitrary frequency band Wilkinson power dividers can be achieved. The 2.4 GHz (WLAN) and 5.9 GHz (DSRC IEEE 802.11p) frequency bands are selected to complement the future development of multi-band, multi-standard transceivers. To improve physical separation and electrical isolation between the two output ports a parallel RLC circuit is employed. For verification, the simulated and measured performance results of dual-band Wilkinson power dividers implemented on the Rogers 4003C laminate are presented. The measurement results for the fabricated Wilkinson power dividers were in good agreement with theoretical simulation results and show dual-band characteristics.</p></abstract>

In this paper, four differently shaped Wilkinson power dividers are presented by selecting the same physical length of two-section transmission lines, dual arbitrary frequency band Wilkinson power dividers can be achieved. The 2.4 GHz (WLAN) and 5.9 GHz (DSRC IEEE 802.11p) frequency bands are selected to complement the future development of multi-band, multi-standard transceivers. To improve physical separation and electrical isolation between the two output ports a parallel RLC circuit is employed. For verification, the simulated and measured performance results of dual-band Wilkinson power dividers implemented on the Rogers 4003C laminate are presented. The measurement results for the fabricated Wilkinson power dividers were in good agreement with theoretical simulation results and show dual-band characteristics.

Design and miniaturization of dual-band Wilkinson power dividers

Department of Computer Science and Communications Technologies

Micro and Nanoelectronics Systems Design and Research Laboratory

Journal of Electrical Engineering

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.

{"article-title":"Design and miniaturization of dual-band Wilkinson power dividers"}

In this paper, four differently shaped Wilkinson power dividers are presented by selecting the same physical length of two-section transmission lines, dual...

Design and miniaturization of dual-band Wilkinson power dividers

Pubblicato online: 24 dic 2020

Pagine: 423 - 427

Ricevuto: 07 lug 2020

DOI: https://doi.org/10.2478/jee-2020-0058

Parole chiave
dual-band, DSRC, RF/microwave circuit, Rogers 4003C, Wilkinson power divider (WPD)

© 2020 Vaidotas Barzdenas et al., published by Sciendo

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.

Design and miniaturization of dual-band Wilkinson power dividers

Pubblicato online: 24 dic 2020

Pagine: 423 - 427

Ricevuto: 07 lug 2020

DOI: https://doi.org/10.2478/jee-2020-0058

Parole chiavedual-band, DSRC, RF/microwave circuit, Rogers 4003C, Wilkinson power divider (WPD)

© 2020 Vaidotas Barzdenas et al., published by Sciendo

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.

Parole chiave
dual-band, DSRC, RF/microwave circuit, Rogers 4003C, Wilkinson power divider (WPD)